Results 141 to 150 of about 118,363 (309)
Advanced Engineering Materials, EarlyView.A combined experimental–computational framework identifies energy‐dependent laser absorptivity for NiTi in laser powder‐bed fusion, applicable to conduction and transition modes. Single‐track experiments and thermofluid smoothed particle hydrodynamics simulations are coupled through inverse analysis of melt pool geometry.
Mohamadreza Afrasiabi +3 more
wiley +1 more source
Nuclear Regulatory Commission Report NUREG/CR-0902
, 1979 Report presenting the results of thermal heat balance power calibration and neutron flux axial distribution measurements for the Power-Cooling-Mismatch Test PCM ...
Vinjamuri, Krishna, Owen, Dennis E.
core
Experimental Characterization of Mycelium‐Based Composites Under Multiple Loading Conditions
Advanced Engineering Materials, EarlyView.This study examines the mechanical response of mycelium‐based composites under compression, shear, and tension using mechanical testing and imaging methods. The comparison between unpressed and hot‐pressed specimens shows that hot pressing is associated with higher compression and shear stiffnesses.
Shaghayegh Elahi +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Molecular dynamics is used to investigate structure refinement during severe plastic deformation. The results show similitude with experimental data. Molecular dynamics simulations of severe plastic deformation of monocrystalline and polycrystalline samples by multiaxial compression of aluminum are carried out.
Roberto B. Figueiredo
wiley +1 more source
CHEOPS Instrument thermal design and test
, 2018 Romain Peyrou-Lauga, ESAGiordano Bruno, University BernICES202: Satellite, Payload, and Instrument Thermal ControlThe 48th International Conference on Environmental Systems was held in Albuquerque, New Mexico, USA on 08 July 2018 through 12 July 2018.The
Bruno, Giordano, Peyrou-Lauga, Romain
core
Advanced Engineering Materials, EarlyView.Si‐doped AlCoCrFeNi high‐entropy alloys are synthesized by mechanical alloying to reveal the effect of Si content and milling time on phase evolution, microstructural refinement, and tribological behavior. A transition from FCC to BCC structure, significant grain refinement, and enhanced hardness and wear resistance are achieved, with the 4 at% Si ...
Mustafa Okumuş +2 more
wiley +1 more source
Thermal Test Campaign of the Solar Orbiter STM
, 2016 NetherlandsUnited KingdomESA/ESTECAirbus Defense & SpaceRHEA203ICES203: Thermal TestingVienna, AustriaC. Damasio, European Space Agency, ESA/ESTECA.Jacobs, Airbus Defence & Space Limited, United KingdomM.
Luengo, Victoria +5 more
core
Advanced Engineering Materials, EarlyView.Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink +4 more
wiley +1 more source
METimage Cryogenic Sub-System STM thermal vacuum test campaign
, 2020 Heiko Joos, Airbus Defence and Space GmbH, DEMarta Bello-Escribano, Airbus Defence and Space GmbH, DEICES108: Thermal Control of Cryogenic Instruments and Optical SystemsThe proceedings for the 2020 International Conference on Environmental Systems were ...
Joos, Heiko, Bello-Escribano, Marta
core
A Two-Stage PPO-RLMPA Framework for Dynamic Economic Dispatch with Renewable Energy and Storage Integration. [PDF]
Biomimetics (Basel)Keskin K.
europepmc +1 more source