Results 231 to 240 of about 3,712,184 (296)

Optimized control, and experimental validation of a novel multi-stage parabolic trough collector for solar water heating systems. [PDF]

Sci Rep
AbdelFatah RT, Shalaby R, Fahim IS, Kasem MM.   +3 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Thermal Bridges

Deep Energy Retrofit, 2020
Alexander Zhivov, Rüdiger Lohse
openaire   +2 more sources

Mitigation of structural thermal bridges

Energy-Efficient Retrofit of Buildings by Interior Insulation, 2022
T. Lohmann
openaire   +2 more sources

Introduction of the combination of thermal fundamentals and Deep Learning for the automatic thermographic inspection of thermal bridges and water-related problems in infrastructures

Quantitative InfraRed Thermography Journal, 2022
Infrastructure inspection is fundamental to keep its service performance at the highest level. For that, special attention should be paid to the most severe defects in order to be able to subsequently mitigate or even eliminate them.
I. Garrido, S. Lagüela, Q. Fang, P. Arias   +3 more
semanticscholar   +1 more source

Thermal behaviors of bridges — A literature review

Advances in Structural Engineering, 2023
This work provides a comprehensive review of previous studies concerning the static thermal behaviors of various types of bridges, including beam bridges, arch bridges, cable-stayed, and suspension bridges.
Lingfang Li, Bo Chen, Lin-ren Zhou, Qi Xia, Yi Zhou, Xiao-qing Zhou, Yong Xia   +6 more
semanticscholar   +1 more source

Thermal conduction of thermal bridges for cryogenic tubing

Chemical and Petroleum Engineering, 1997
Tubing with breakable joints of various types are widely used in cryogenic systems. Themost widely used are the bayonet joints.
Ya. L. Brailovskii, B. G. Blyukher
openaire   +1 more source

Thermally driven micromechanical bridge resonators

Sensors and Actuators A: Physical, 1994
Abstract This paper reports the fabrication and characterization of bridge resonators made of single-crystal silicon. The fabrication process involves anisotropic etching in combination with an electrochemical etch-stop technique to obtain uniform membranes and RIE etching to free the bridges.
Chr. Burrer, J. Esteve
openaire   +1 more source

Dynamic calculation of thermal bridges

Energy and Buildings, 1997
Abstract Thermal bridges play a relatively large role in heat loss with increasing thermal insulation level of building envelope. In this paper, multi-dimensional dynamic models are set up to predict the thermal performances of thermal bridges using a frequency response method.
Guofeng Mao, Gudni Johannesson
openaire   +1 more source

HEAT LOSS FROM THERMAL BRIDGES

Batiment International, Building Research and Practice, 1984
(1984). HEAT LOSS FROM THERMAL BRIDGES. Batiment International, Building Research and Practice: Vol. 12, No. 6, pp. 346-352.
J.B. Fang, R.A. Grot, K.W. Childs, G.E. Courville   +3 more
openaire   +1 more source

Thermal Behavior of Composite Bridges

Journal of Structural Engineering, 1990
This paper presents the analytical results obtained from a parametric study on the thermal behavior of three types of composite bridge structures subjected to solar radiation, namely, a plate-girder, a single-cell box, and a two-cell box-girder concrete-steel composite bridge. A series of transient temperature distributions and the thermal stresses for
Fu, H.C., Ng, S.F., Cheung, Mo Shing
openaire   +1 more source