Results 141 to 150 of about 203,544 (317)
CALCULATION OF CONTACT THERMAL RESISTANCE
Modern Technologies and Scientific and Technological ProgressAn approach to determining the contact thermal resistance of two-layer materials and the results of comparing the analytical determination of thermal resistance with experimental data are considered. The necessity of taking into account the contact thermal resistance in the design of heat exchangers is ...
Sergey Scherbin, Viktor Kolesnichenko
openaire +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Designing photovolaic/thermal solar collectors for building integration
, 2008 With concern growing over the environment and resource use, there has been greater emphasis placed on sustainability, particularly in the built environment.
Carson, James K. +2 more
core
Laser Powder Bed Fusion of Alumina: Effects of Scanning Strategies on External and Internal Defects
Advanced Engineering Materials, EarlyView.This study investigates how scanning strategies affect pure alumina in laser powder bed fusion. Linear 45° scanning yields uniform surfaces but high porosity, while the island‐concentric strategy provides higher density with through‐holes favorable for infiltration. Findings highlight pathways toward optimizing defect‐free alumina parts.
Mohamed Abdelmoula +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
The relationship between porosity and thermal conductivity of concrete [PDF]
, 1990 This thesis reports the details and results of an experimental study into the effect of porosity on the thermal conductivity of lightweight and normal-weight concretes.
Ganjian, Esmaiel
core
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
, 2012 A numerical analysis is performed to systematically calculate the performance, rotor temperature distributions, and rotor thermal deformation of an R134a screw compressor. The analysis procedure includes three major steps.
Hsieh, Wenhsin +3 more
core