Results 121 to 130 of about 368,346 (339)
Heat conduction through a trapped solid: the effect of structural changes on the thermal conductance [PDF]
, 2007 Debasish Chaudhuri +2 more
openalex +1 more source
Advanced Engineering Materials, EarlyView.A novel, temperature‐controlled post‐consolidation unit is developed to test its potential to improve the melt impregnation process used to manufacture continuous fiber‐reinforced filaments for additive manufacturing of high‐performance thermoplastics.
Daniel Beermann +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Cr0.9Si0.1 protective coatings are developed to enhance the thermal‐shock and oxidation resistance of Mg2Si0.89(Sn0.1,Sb0.01) thermoelectric (TE) materials. The coating forms a dense and adherent barrier that suppresses oxygen diffusion and mitigates mechanical degradation during cyclic oxidation, demonstrating its potential to improve the long‐term ...
Mikdat Gurtaran +3 more
wiley +1 more source
On the thermal durability of solar prominences, or how to evaporate a prominence [PDF]
The thermal disappearance of solar prominences under strong perturbations due to wave heating, Ohmic heating, viscous heating or conduction was investigated. Specifically, how large a thermal perturbation is needed to destroy a stable thermal equilibrium
Forbes, T. G., Malherbe, J. M.
core +1 more source
Advanced Engineering Materials, EarlyView.Plasma‐assisted hybrid friction stir welding of dissimilar AlCu joints employs localized plasma preheating to balance heat input and enhance plastic flow. The optimized process reduces axial force by up to 35%, refines the microstructure, and achieves ≈96% joint efficiency.
Deepak Kumar Yaduwanshi +3 more
wiley +1 more source
ModellingThis paper presents a new semi-explicit algorithm for parameters estimation in a time-fractional generalization of a dual-phase-lag heat conduction model with Caputo fractional derivatives. It is shown that this model can be derived from a general linear
Stanislav Yu. Lukashchuk
doaj +1 more source
Atomic-level breakdown of Green-Kubo relations provides new insight into the mechanisms of thermal conduction. [PDF]
Sci Rep, 2021 Manjunatha L, Takamatsu H, Cannon JJ.
europepmc +1 more source
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6
Advanced Engineering Materials, EarlyView.The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
wiley +1 more source
Quantitative analysis of heat dissipation in a micro thermal stage for a broad temperature operation
Case Studies in Thermal EngineeringA microscale thermal stage offers precise temperature control by suppressing heat conduction. For its use in a broad range of temperatures, the temperature accuracy has been under debate as both conduction and radiation become important heat paths.
Eunju Jeong +3 more
doaj +1 more source
A Molecular Model of PEMFC Catalyst Layer: Simulation on Reactant Transport and Thermal Conduction. [PDF]
Membranes (Basel), 2021 Wang W, Qu Z, Wang X, Zhang J.
europepmc +1 more source