Results 111 to 120 of about 764,032 (331)

High-temperature electrical and thermal transport properties of fully filled skutterudites RFe_(4)Sb_(12) (R = Ca, Sr, Ba, La, Ce, Pr, Nd, Eu, and Yb) [PDF]

, 2011
Fully filled skutterudites RFe_(4)Sb_(12) (R = Ca, Sr, Ba, La, Ce, Pr, Nd, Eu, and Yb) have been prepared and the high-temperature electrical and thermal transport properties are investigated systematically.
Chen, L. D., Huang, X. Y., Liu, R. H., Qiu, P. F., Shi, X., Snyder, G. J., Yang, J., Zhang, W.   +7 more
core  

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

Investigation of Thermo‐Chemical Processes in Commercial MgO‐C Refractory Bricks With and Without MgO‐C Recyclate at Elevated Temperatures

Advanced Engineering Materials, EarlyView.
This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm, Jana Hubálková, Christian Schimpf, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +6 more
wiley   +1 more source

Optimization direction and selection strategy for thin film thermoelectric cooler materials

Case Studies in Thermal Engineering
While thin-film thermoelectric coolers (TECs) are promising for chip thermal management, their material optimization strategy remains controversial. Conventional approaches focus on improving the material's figure of merit (ZT) by enhancing the power ...
Leyao Chu, Bingxuan Niu, Changbo Bu, Xiaolin Liang, Huazhong Zhang, Zhichun Liu, Yubo Tan, Limei Shen, Yongjun Sun   +8 more
doaj   +1 more source

Combined Process‐ and Phase‐Field‐Simulation to Predict the Microstructure of Single‐Crystal Ni‐Based Superalloys

Advanced Engineering Materials, EarlyView.
A combined finite element and phase‐field approach predicts the evolution of microstructure during the directional solidification of Ni‐based superalloys. The model reveals how withdrawal rate, temperature gradient, and wall thickness control the dendrite spacing, highlighting the strong effect of surface regions in thin sections where dendrite growth ...
Sean Böhm, André B. Baldissera, Rainer Völkl, Uwe Glatzel   +3 more
wiley   +1 more source

Heat Transfer and Thermal Expansion of Coefficient EP -(MWCNT/x-TiO2)Nanocomposites

Journal of Engineering, 2018
The thermal properties (thermal transfer and thermal expansion coefficient) of the enhanced epoxy resin (MWCNT / x-TiO2) were studied by weight ratios with the values (0%, 3%, 5%, 7% and 10%) and a constant ratio of 3% of MWCNT. The ultrasonic technology
Dhilal Amer Sabar, Fadhil K. Farhan
doaj   +1 more source

Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio

Advanced Engineering Materials, EarlyView.
This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov, Matheus Roberto Bellé, Anton Yehorov, Julia Richter, Olena Volkova   +4 more
wiley   +1 more source

Synthesis and Properties of Highly Efficient Thermoelectric Materials Based on Lead Telluride with Antimony and Silver Impurity

Фізика і хімія твердого тіла, 2016
The paper presents the results of research of X-ray diffraction and thermoelectric parameters (thermoelectric coefficient α, electrical conductivity σ and thermal conductivity coefficient k) of materials based on Lead Telluride: PbTe, PbTe:Sb, PbTe ...
D. M. Freik, S. I. Mudriy, Ts. A. Kriskov, I. V. Gorіchok, O. M. Matkіvsky, T. O. Semko   +5 more
doaj   +1 more source

THE COEFFICIENT OF THERMAL CONDUCTIVITY OF EYE AND ORBIT [PDF]

Journal of the American Medical Association, 1922
This paper is a continuation of one 1 which was presented at the meeting of the Section on Ophthalmology of the American Medical Association at New Orleans in April, 1920. As the terms cold, warmth and heat are relative, in this connection I shall consider that cold means any low temperature up to about 15 C.; but it is considered zero unless otherwise
openaire   +1 more source

Population of Nonmetallic Inclusions in Liquid High‐Silicon Electrical Steel in Contact With MgO–C Refractories Based on Recyclates and Environmentally Friendly Binders

Advanced Engineering Materials, EarlyView.
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert, Matheus Roberto Bellé, Florian Kerber, Dinesh Kumar Gunasekar, Hans‐Jörn Weddige, Christos G. Aneziris, Olena Volkova   +6 more
wiley   +1 more source