Results 11 to 20 of about 26,517,134 (293)
A novel approach for ANFIS modelling based on Grey system theory for thermal error compensation [PDF]
, 2014 The fast and accurate modelling of thermal errors in machining is an important aspect for the implementation of thermal error compensation. This paper presents a novel modelling approach for thermal error compensation on CNC machine tools.
Fletcher, Simon +2 more
core +5 more sources
Fluidic and mechanical thermal control devices [PDF]
, 2021 In recent years, intensive studies on thermal control devices have been conducted for the thermal management of electronics and computers as well as for applications in energy conversion, chemistry, sensors, buildings, and outer space.
Andrej Kitanovski +8 more
core +2 more sources
Obstacle detection using thermal imaging sensors for large passenger airplane [PDF]
, 2012 This thesis addresses the issue of ground collision in poor weather conditions. As bad weather is an adverse factor when airplanes are taxiing, an obstacle detection system based on thermal vision is proposed to enhance the awareness of pilots during ...
Shi, Jie
core +7 more sources
Solid-state thermal control devices [PDF]
, 2021 Over the past decade, solid-state thermal control devices have emerged as potential candidates for enhanced thermal management and storage. They distinguish themselves from traditional passive thermal management devices in that their thermal properties ...
Yalamarthy, Ananth +10 more
core +2 more sources
Flow Distribution Characteristics in Microchannel Heat Sinks in Pumping Liquid Cooling System
Shanghai Jiaotong Daxue xuebao, 2023 With the continuous improvement of pump-driven liquid cooling requirements for electronic devices, the cooling requirements for multiple dispersed units are inevitable, resulting in higher requirements of equal cooling capacity for parallel microchannel ...
XIN Pengfei, MIAO Jianyin, KUANG Yiwu, ZHANG Hongxing, WANG Wen
doaj +1 more source
Thermal comfort based fuzzy logic control [PDF]
, 2001 Most heating, ventilation and air conditioning (HVAC) control systems are considered as temperature control problems. In this work, the predicted mean vote (PMV) is used to control the indoor temperature of a space by setting it at a point where the PMV ...
Underwood, Chris +2 more
core +1 more source
Assessment of vibration suppression methods for spacecraft electric pump unit
Космические аппараты и технологии, 2023 This article characterizes the spacecraft as a means of performing various tasks, including by precision equipment. Emphasis is placed on vibration as one of the influencing factors and on the need for a low level of vibration on the spacecraft.
O. V. Shirobokov +3 more
doaj +1 more source
Applied Sciences, 2020 Copper foam is widely used in industrial catalysis, flow boiling, and latent heat storage systems. It is expected that a multi-level topology copper foam with micro/nanostructures can further enhance performance.
Mou Xu +4 more
doaj +1 more source
Dynamic Characteristics and Experimental Research of Dual-Rotor System with Rub-Impact Fault
Shock and Vibration, 2016 Rub-impact fault model for dual-rotor system was further developed, in which rubbing board is regarded as elastic sheet. Sheet elastic deformation, contact penetration, and elastic damping support during rubbing of sheet and wheel disk were considered ...
Hongzhi Xu +4 more
doaj +1 more source
Авіаційно-космічна техніка та технологія, 2021 Spacecraft thermal control systems based on two-phase mechanically pumped loops have advantages in terms of mass and power consumption for auxiliary needs compared to single-phase thermal control systems.
Artem Hodunov +2 more
doaj +1 more source