Results 181 to 190 of about 6,411,821 (351)

Synergistic effects of atomic oxygen and thermal cycling in low earth orbit on polymer-matrixed space material. [PDF]

Heliyon, 2023
Zhai R, Yang X, Jiang L, Gao H, Zhang Y, Jiao Z.   +5 more
europepmc   +1 more source

THERMAL CYCLING OF URANIUM

, 1952
N. Stetson, M. L. Winton
openaire   +2 more sources

Experimental Characterization of Mycelium‐Based Composites Under Multiple Loading Conditions

Advanced Engineering Materials, EarlyView.
This study examines the mechanical response of mycelium‐based composites under compression, shear, and tension using mechanical testing and imaging methods. The comparison between unpressed and hot‐pressed specimens shows that hot pressing is associated with higher compression and shear stiffnesses.
Shaghayegh Elahi, Kimiya Tajik, Harvey Shaw, Matti Isakov, Sami Pajunen, Lauri Rautkari   +5 more
wiley   +1 more source

Cross Comparison Between Thermal Cycling and High Temperature Stress on I/O Connection Elements. [PDF]

Micromachines (Basel)
Dhyani M, Avraham T, Bernstein JB, Bender E.   +3 more
europepmc   +1 more source

Deformation Prediction Theory of Thermal Barrier Coatings near Cooling Holes under Thermal Cycling. [PDF]

ACS Omega, 2023
Wang JX, Sun HT, Gong QT, Li FX, Li ZZ.
europepmc   +1 more source

Reconfigurable Logic‐in‐Memory Operations Enabled by Triple‐Gated Feedback Field‐Effect Transistors for Area‐Efficient Computing

Advanced Engineering Materials, EarlyView.
A reconfigurable logic‐in‐memory cell composed of triple‐gated feedback field‐effect transistors implements multiple combinational logic functions within a single configuration. By utilizing program gates as dynamic input terminals, the proposed cell performs full adder, full subtractor, 2‐to‐1 multiplexer, and 4‐to‐2 encoder operations without ...
Minhyeok Seol, Yunwoo Shin, Donghyung Lee, Dongki Kim, Kyoungah Cho, Sangsig Kim   +5 more
wiley   +1 more source

Insights into the operational stability of wide-bandgap perovskite and tandem solar cells under rapid thermal cycling. [PDF]

Nat Commun
Sun K, Guo R, Zhou Q, Fang L, Jiang X, Wegener SA, Liang Y, Li Z, Liang S, Schwartzkopf M, Aydin E, Koyiloth Vayalil S, Roth SV, Paetzold UW, Müller-Buschbaum P.   +14 more
europepmc   +1 more source

Test Structure Design for Defect Detection during Active Thermal Cycling. [PDF]

Sensors (Basel), 2022
Florea C, Simon D, Bojiță A, Purcar M, Boianceanu C, Țopa V.   +5 more
europepmc   +1 more source

Influence of Si Content and Milling Duration on the Microstructure and Mechanical–Tribological Properties of AlCoCrFeNiSi High‐Entropy Alloys

Advanced Engineering Materials, EarlyView.
Si‐doped AlCoCrFeNi high‐entropy alloys are synthesized by mechanical alloying to reveal the effect of Si content and milling time on phase evolution, microstructural refinement, and tribological behavior. A transition from FCC to BCC structure, significant grain refinement, and enhanced hardness and wear resistance are achieved, with the 4 at% Si ...
Mustafa Okumuş, Mehmet Emin Demir, Sercan Özpınar   +2 more
wiley   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source