Results 151 to 160 of about 123,905 (309)
Jixie qiangdu, 2017 The thermal deformation of the hydrostatic motorized spindle affects seriously machining precision,so it is necessary to analyze the effect factors of the thermal deformation of motorized spindle system. The process parameter and structural parameter are
YAN ChaoYing +3 more
doaj
Biocomposite from polylactic acid and lignocellulosic fibers: structure-property correlations
, 2013 PLA biocomposites were prepared using three corncob fractions and a wood fiber as reference. The composites were characterized by tensile testing, scanning electron (SEM) and polarization optical (POM) microscopy.
Renner, Károly +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.This work shows that the mechanical performance of multimaterial digital light processing (DLP) printed thermoset composites is governed by resin compatibility and interfacial design rather than spatial patterning alone. Brittle and ductile resin combinations produced premature interfacial failure, while graded interfaces and mechanically compatible ...
Ahmed M. H. Ibrahim +3 more
wiley +1 more source
Highly efficient thermal deformation optimization method for smart-cut mirrors over the entire photon energy range. [PDF]
J Synchrotron Radiat, 2022 Wang S +6 more
europepmc +1 more source
Deep Underground Science and EngineeringChinese coal reservoirs are characterized by low pressure and low permeability, which need to be enhanced so as to increase production. However, conventional methods for permeability enhancement can only increase the permeability in fractures, but not ...
Zhiqiang Li +9 more
doaj +1 more source
Feasibility of Nitrogen as a Carrier Gas for Inconel Cold Spray in Hydropower Application
Advanced Engineering Materials, EarlyView.N2, despite being nearly two orders of magnitude cheaper than He, is a feasible carrier gas for cold spray Inconel coatings in hydropower repair applications when higher gas temperature and pressure are used. Reducing powder size significantly improved cavitation resistance, while the addition of fine chromium carbide particles further enhanced erosion
Tianhao Wang +4 more
wiley +1 more source
Microstructure and Thermal Deformation Behavior of Hot-Pressing Sintered Zr-6Al-0.1B Alloy. [PDF]
Materials (Basel), 2022 Yan H +5 more
europepmc +1 more source
MILLING TOOL DEFORMATION CAUSED BY HEATING DURING THE CUTTING PROCESS [PDF]
, 2014 The presented paper describes an experiment dealing with the deformation of a milling tool caused by heating during the cutting process. Based on the literature review an experimental procedure is designed to simulate heating of the milling tool during ...
Brajer J. +3 more
core
Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading
Advanced Engineering Materials, EarlyView.This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev +2 more
wiley +1 more source
Behaviour of Thermal Deformation of Steel Cr5 for Cold Working Roll
Teshugang, 2009 Behaviour of thermal deformation of steel Cr5 (% ：0.85C, 5.0Cr, 0.6Si, 0.5Ni, 0.4Mo, 0.1V) with stain rate 0.001 〜1 s-1 at 900 ~ 1200 °C has been studied by using Gleeble-3500 thermal simulator.
李倩 +4 more
doaj