Results 51 to 60 of about 797,519 (300)

Industrial application experiment series [PDF]

, 1980
Two procurements within the Industrial Application Experiment Series of the Thermal Power Systems Project are discussed. The first procurement, initiated in April 1980, resulted in an award to the Applied Concepts Corporation for the Capital Concrete ...
Bluhm, S. A.
core   +2 more sources

Synthesis of a Novel Thermoresponsive S53P4 Bioactive Glass Extract–Poloxamer 407 Injectable Hydrogels: Assessment of Biocompatibility and Antimicrobial Properties

Advanced Engineering Materials, EarlyView.
This study investigates innovative thermoreversible hydrogels derived from S53P4 bioactive glass extracts to aid in the healing of infected diabetic foot wounds. These injectable gels, which gel at body temperature, release beneficial ions and remain stable over time.
Marian G. Vargas Guerrero, Adrian Stiller, Alex Nygård, Matej Krivulka, Lars Galema, Erwin Peters, Jimmy Lucchesi, Peter Uppstu, Leena Hupa, Jacobus J. C. Arts   +9 more
wiley   +1 more source

Research on the Operation Flexibility of a Combined Heat and Power Generation Unit with Low-Temperature Return Water

Energies
In northern China, photovoltaic power generation peaks around midday, resulting in a concentrated demand for flexible and deep peak shaving over a period of approximately four hours.
Yaohua Zhao, Lei Lei, Shaohua Li, Junfu Lyu   +3 more
doaj   +1 more source

Analysis of Primary Frequency Regulation Ability of Shandong Power Grid Thermal Power Unit

Journal of Physics: Conference Series, 2021
Abstract Shandong Power Grid is about to achieve the development goal of 30% of new energy power generation installed capacity, 30% of foreign power input into Shandong, and 30% of thermal power installed capacity. Neither new energy power generation nor external power has the ability to adjust primary frequency.
En Ren Liu, Jun Li, Song Gao, Xiang rong Meng, Shuo Shi, Qingbin Yu, Yuan yuan Li, Qing Yan   +7 more
openaire   +1 more source

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

Advanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé, Lukas Neubert, Anton Yehorov, Till M. J. Stadtmüller, Christos G. Aneziris, Olena Volkova   +5 more
wiley   +1 more source

Energy, Environmental, and Economic Analyses of a District Heating (DH) Network from Both Thermal Plant and End-Users’ Prospective: An Italian Case Study

Energies, 2021
District heating (DH) is an alternative technology to Individual Heating (IH) for satisfying end-user’s needs. This paper assesses the competitiveness of a DH network in the center of Italy from energy, environmental, and economic points of view ...
Erica Corradi, Mosè Rossi, Alice Mugnini, Anam Nadeem, Gabriele Comodi, Alessia Arteconi, Danilo Salvi   +6 more
doaj   +1 more source

Dynamic Control Method of Thermal Power Units Compensating for Wind Power Disturbance

IOP Conference Series: Earth and Environmental Science, 2019
Abstract The randomness and volatility of wind power generation are the main reasons restricting the capacity of power grid to absorb wind power. Thermal power units are the main force of power grid frequency modulation. The speed of load adjustment rate determines their response ability to power grid load.
Jun Li, Ting Wang, XiangRong Meng, Jie Li, Song Gao, Bo Lin   +5 more
openaire   +1 more source

Can switching fuels save water? A life cycle quantification of freshwater consumption for Texas coal-and natural gas-fired electricity [PDF]

, 2012
Thermal electricity generation is a major consumer of freshwater for cooling, fuel extraction and air emissions controls, but the life cycle water impacts of different fossil fuel cycles are not well understood.
Beach, Fred C., Grubert, Emily A., Webber, Michael E.   +2 more
core   +2 more sources

A Thermodynamic 3D Model for the Simulation of Diffusion‐Controlled Alloying Processes in Heterogeneous Material Structures

Advanced Engineering Materials, EarlyView.
A numerical model resulting from irreversible thermodynamics for describing transport processes is introduced, focusing on thermodynamic activity gradients as the actual driving force for diffusion. Implemented in CUDA C++ and using CalPhaD methods for determining the necessary activity data, the model accurately simulates interdiffusion in aluminum ...
Ulrich Holländer, Leonhard Holländer, André Langohr, Hans Jürgen Maier   +3 more
wiley   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

Advanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek, Jakub Hurník, Miroslav Šmíd, Ondřej Zobač, Melanie Todt, Daniel Koutný   +5 more
wiley   +1 more source