Results 21 to 30 of about 7,550,470 (225)
Investigating the thermal stability of 1-3 piezoelectric composite transducers by varying the thermal conductivity and glass transition temperature of the polymeric filler material [PDF]
, 2002 The thermal behaviour of a number of 1-3 piezoelectric composite transducers is discussed. In particular, devices manufactured from a polymer filler with a relatively high glass to rubber transition temperature (T-g), and from polymer systems with ...
Hayward, G. +6 more
core +4 more sources
Thermal Characterization of Phantoms Used for Quality Assurance of Deep Hyperthermia Systems
Sensors, 2020 Tissue mimicking phantoms are frequently used in hyperthermia applications for device and protocol optimization. Unfortunately, a commonly experienced limitation is that their precise thermal properties are not available.
Laura Farina +3 more
doaj +1 more source
eXPRESS Polymer Letters, 2023 The influence of the reduction of macromolecular entanglements on the thermal and mechanical properties of polylactide composites containing 0.1–1.0 wt% of carbon nanotubes was investigated.
Hoorieh Barangizi +2 more
doaj +1 more source
Thermal properties of vesicular rhyolite [PDF]
, 1994 Thermal diffusivity of rhyolite melt and rhyolite foam (70–80% porosity) has been measured using the radial heat transfer method. Cylindrical samples (length 50–55 mm, diameter 22 mm) of rhyolite melt and foam have been derived by heating samples of ...
Bagdassarov, Nikolai +1 more
core +1 more source
Nanomaterials, 2020 Fabrication of low-cost, durable and efficient metal oxide nanocomposites were successfully synthesized and reinforced with photo-resin via 3-dimensional printing.
Suhail Mubarak +6 more
doaj +1 more source
Case Studies in Thermal Engineering, 2021 In this research, microstructures, thermal and electric properties of thin-film bismuth vanadium oxide as an anode for water electrolysis were presented. The anodes needed are obtained by centrifuging the indium thin oxides with BiVO4 powder. In order to
Achmad Walid +3 more
doaj +1 more source
Molecules, 2021 Three-dimensional (3D) printing manufactures intricate computer aided designs without time and resource spent for mold creation. The rapid growth of this industry has led to its extensive use in the automotive, biomedical, and electrical industries.
Elizabeth Diederichs +4 more
doaj +1 more source
Study on properties of composites reinforced by heat treated glass fibres simulating thermal recycling conditions [PDF]
, 2013 In the present study, commercial chopped glass fibres were heat treated at 300°C, 450°C, 500°C and 600°C to imitate a composite thermal recycling process.
Thomason, James +2 more
core +3 more sources
Thermal Properties of TiO2/PbS Nanoparticle Solar Cells
Nanomaterials and Nanotechnology, 2012 Photovoltaic performance is shown to depend on ligand capping on PbS nanoparticle solar cells by varying the temperature between 140K and 350K. The thermal response of open‐circuit voltage, short‐circuit current density, fill‐factor and shunt resistance ...
Derek Padilla +5 more
doaj +1 more source
eXPRESS Polymer Letters, 2015 In the present study, the effect of nano magnetite (Fe3O4) content on structural, dielectric/electrical, magnetic and thermal properties of poly(vinylidene fluoride)/carbon nanotubes matrix, is investigated. Nanocomposite films of polyvinylidene fluoride,
C. Tsonos +7 more
doaj +1 more source