Results 181 to 190 of about 4,210 (262)

The Influence of Residual Ion Drift During Programming of Chip‐Integrated Nanoscale HfO2‐Based Memristive Devices

open access: yesAdvanced Electronic Materials, EarlyView.
1T1R‐arrays combining filamentary‐type memristors and CMOS transistors offer great potential for energy‐efficient analog hardware accelerators. Here, transient SET analysis of nanoscale HfO2 memristors integrated on 180 nm CMOS wafers is discussed.
Oliver Artner   +11 more
wiley   +1 more source

Controlling Self‐Doping in Conjugated Polyelectrolyte Copolymers to Vary the Threshold Voltage in OECTs

open access: yesAdvanced Electronic Materials, EarlyView.
Two series of self‐doped conjugated polyelectrolytes are synthesized from a non‐self‐dopable building block 3MEEET and a self‐dopable building‐block 3HOT−[TMA+] or 3HOT−[SO3H] enabling precise control over the degree of self‐doping, which in turn directly governs the threshold voltage (VT) in OECTs over a wide range of 700 mV.
Julian Hungenberg   +7 more
wiley   +1 more source

Anion‐Cation Synergistic Passivation for High‐Performance FA‐Cs Halide Perovskite Photodetectors

open access: yesAdvanced Electronic Materials, EarlyView.
An anion‐cation synergistic passivation strategy is developed to improve perovskite photodetectors. Surface‐localized DMePDA2+ cations and bulk‐diffused Cl− anions simultaneously reduce defects, enhancing charge transport and suppressing recombination.
Hyeon‐Jong Shin   +3 more
wiley   +1 more source

Advancing Energy Materials by In Situ Atomic Scale Methods

open access: yesAdvanced Energy Materials, Volume 15, Issue 11, March 18, 2025.
Progress in in situ atomic scale methods leads to an improved understanding of new and advanced energy materials, where a local understanding of complex, inhomogeneous systems or interfaces down to the atomic scale and quantum level is required. Topics from photovoltaics, dissipation losses, phase transitions, and chemical energy conversion are ...
Christian Jooss   +21 more
wiley   +1 more source

Fabrication of Composite Cathode for All‐Solid‐State Sodium Batteries

open access: yesAdvanced Energy Materials, EarlyView.
The design of composite cathodes for all‐solid‐state sodium batteries must address three critical challenges—interfacial side reactions, interfacial delamination, and highly tortuous transport pathways. This work outlines structural and interfacial strategies to optimize ion transport and mechanical stability, enabling durable, and high‐performance ...
Gaoming Sun   +6 more
wiley   +1 more source

From Materials to Systems: Challenges and Solutions for Fast‐Charge/Discharge Na‐Ion Batteries

open access: yesAdvanced Energy Materials, EarlyView.
This review systematically analyzes the key characteristics limiting the fast‐charge/discharge capability of Na‐ion batteries (SIBs) from a multi‐scale perspective encompassing electrode materials, the electrode‐electrolyte interface, and the system. Furthermore, it presents practical solution strategies for the fundamental issues arising at each scale,
Bonyoung Ku   +5 more
wiley   +1 more source

Dataset of mechanically induced thermal runaway measurement and severity level on Li-ion batteries. [PDF]

open access: yesData Brief
Lin L   +8 more
europepmc   +1 more source

Decoding Gas Evolution Pathways and Interfacial Chemistry in Layered Oxide Cathodes for Safer Sodium‐Ion Batteries

open access: yesAdvanced Energy Materials, EarlyView.
Gas evolution behaviors of sodium layered oxide cathodes with varying compositions, cutoff voltages, dopants, and particle sizes/morphologies have been systematically investigated by online electrochemical mass spectrometry. The fundamental outgassing mechanisms of sodium‐based cathodes compared to lithium‐based cathodes have been elucidated.
Chen Liu, Zehao Cui, Arumugam Manthiram
wiley   +1 more source

Home - About - Disclaimer - Privacy