Results 51 to 60 of about 73,780 (289)
Method of making pressure tight seal for super alloy [PDF]
, 1973 A procedure for forming a pressure tight seal along two edges of super alloy sheets is presented. The procedure consists of flame spraying a powdered aluminum-nickel composition on the joint.
Little, R. E.
core +1 more source
Advanced Engineering Materials, EarlyView.Fungal mycelia grown into biodegradable scaffolds and infused with titania nanoparticles show enhanced ultraviolet shielding, thermal protection, and surface nonwettability. Properties were tuned by drying methods, revealing structure–function relationships.
Juwon S. Afolayan +2 more
wiley +1 more source
Surface modification of plasma spraying Al2O3–13 wt% TiO2 coating by laser remelting technique
Materials Research Express, 2022 An Al _2 O _3 –13 wt% TiO _2 composite ceramic coating was prepared on the TiAl alloy surface by plasma spraying and laser remelting combined technique.
Yan Zhou +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
Buildings, 2019 The purpose of this study was to investigate the effects of building microclimate on the indoor thermal environment of traditional Japanese houses, focusing especially on the shading effect of trees as well as the cooling effect of spraying water ...
Ayaz Fazeel Hosham, Tetsu Kubota
doaj +1 more source
Advanced Engineering Materials, EarlyView.New features on yttria‐stabilized zirconia after exposure at 1500°C: Newly discovered pyramidal structures on an old material. After exposure at 1550°C on the cross section of YSZ new features, namely pyramidal structures are discovered. These structures grow with time, increase in numbers, appear as singularities, are often arranged in strings, and ...
Doris Sebold +2 more
wiley +1 more source
Hydrodynamic air lubricated compliant surface bearing for an automotive gas turbine engine. 2: Materials and coatings [PDF]
, 1978 Material coatings for an air-lubricated, compliant journal bearing for an automotive gas turbine engine were exposed to service test temperatures of 540 C or 650 C for 300 hours, and to 10 temperature cycles from room temperatures to the service test ...
Bhushan, B., Gray, S., Ruscitto, D.
core +2 more sources
Advanced Functional Materials, EarlyView.Intelligent radiative cooling devices, adaptable to various weather conditions, have the potential for year‐round energy savings. This study introduces a sustainable dual‐mode film made from polycaprolactone nanofibers and upcycled chip bags for effective thermal management.
Qimeng Song +4 more
wiley +1 more source
BuildingsMist spraying is an active cooling technology used to alleviate heat stress during hot summers. However, there is limited experimental research on the relationship between ambient thermal parameters and spray cooling efficiency, as well as the transient ...
Pin Wang +4 more
doaj +1 more source
Progress in Research on Bonding Interface Between Thermal Spraying Coating and Substrate
Cailiao gongcheng, 2017 In the process of thermal spraying remanufacturing,a heterogenerous bonding interface always exists between the coating and matrix due to the materials reason.And the formation and existence of the bonding interface has a significant influence on the ...
LIU Jian +4 more
doaj +1 more source