Results 151 to 160 of about 991,745 (315)
Review of Molten-Salt Thermocline Tank Modeling for Solar Thermal Energy Storage
, 2013 Molten-salt thermocline tanks are a low-cost option for thermal energy storage in concentrating solar power systems. A review of previous experimental and numerical thermocline tank studies is performed to identify key issues associated with tank design ...
Yang, Z. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Predicting extreme defects in additive manufacturing remains a key challenge limiting its structural reliability. This study proposes a statistical framework that integrates Extreme Value Theory with advanced process indicators to explore defect–process relationships and improve the estimation of critical defect sizes. The approach provides a basis for
Muhammad Muteeb Butt +8 more
wiley +1 more source
Application of the thermal time model for different Typha domingensis populations. [PDF]
BMC Plant Biol, 2020 Carhuancho León FM +3 more
europepmc +1 more source
, 2007 Underbonnet simulations are proving to be crucially important within a vehicle development programme, reducing test work and time-to-market. While computational fluid dynamics (CFD) simulations of steady forced flows have been demonstrated to be reliable,
Franchetta, M. +2 more
core
Obstacle detection using thermal imaging sensors for large passenger airplane [PDF]
, 2012 This thesis addresses the issue of ground collision in poor weather conditions. As bad weather is an adverse factor when airplanes are taxiing, an obstacle detection system based on thermal vision is proposed to enhance the awareness of pilots during ...
Shi, Jie
core
, 2009 The potential for directional optical and thermal imagery is very large. Field measurements have been performed with a goniometer on which thermal instruments were attached.
Christiaan van der Tol +13 more
core +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Laser Powder Bed Fusion of Alumina: Effects of Scanning Strategies on External and Internal Defects
Advanced Engineering Materials, EarlyView.This study investigates how scanning strategies affect pure alumina in laser powder bed fusion. Linear 45° scanning yields uniform surfaces but high porosity, while the island‐concentric strategy provides higher density with through‐holes favorable for infiltration. Findings highlight pathways toward optimizing defect‐free alumina parts.
Mohamed Abdelmoula +7 more
wiley +1 more source
Thermal Modelling of the Ventilation and Cooling inside Axial Flux Permanent Magnet Generators [PDF]
, 2010 Axial flux permanent magnet generators are of particular interest for power generation in harsh and confined conditions. Due to their compactness and high power density, the ventilation and cooling inside axial flux permanent magnet generators have ...
LIM, CHIN,HONG, Lim, Chin Hong
core
Advanced Engineering Materials, EarlyView.This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source