Results 61 to 70 of about 595,419 (195)
Trends in the development of thermo-chemical treatment of steel
, 1985 The subject of discussion are the up-do-date trends in the development of thermo-chemical treatment realized by: - improvement or change in physical aspect of process (application of fluidized media, utilization of glow discharge, rapid electric ...
Siepak, Jerzy, Serczyk, Jan
core
Functional fatigue in NiTi shape memory alloy wires - A comparative study [PDF]
, 2012 The functional fatigue behaviour of two near equi-atomic NiTi shape memory alloy wires obtained from different sources were evaluated. Results showed that though the wires had similar transformation temperatures and mechanical properties, their ...
Ramaiah, KV +3 more
core
Наука и техника, 2007 Optimization of saturating mixture compositions has been carried out in two three-component systems, namely: Cr-Ti-V and Cr-Ti-Mn in respect of micro-hardness and wear resistance of carbide coatings obtained by thermo-chemical treatment of high carbon ...
A. A. Shmatov
doaj +1 more source
, 2014 Objective: This study focuses on the fatigue behavior of titanium dental implants as-received, with a grit-blasted surface and with a new bioactive surface treatment (2Steps). Background: The 2Step process consists of (1) an initial grit-blasting process
Jose Maria Llamas +7 more
core +1 more source
Physical and Chemical Water Quality of Ilam Water Treatment Plant [PDF]
Water usually has some dissolved elements such as solids and gasses. Existences of some elements in water are necessary for human health, but deficiency of many them can cause problems.
تردست, علی +6 more
core
Residual stresses and fatigue resistance of toothed wheels
Вестник Самарского университета: Аэрокосмическая техника, технологии и машиностроение, 2018 Residual stresses in the dangerous section of toothed wheels made of materials and according to practices accepted in aviation engine construction have been determined using a mechanical method. The influence of the technology of manufacturing of toothed
V. S. Vakulyuk +3 more
doaj +1 more source
Active pore materials based on sludges of Cr-Ni alloy electrochemical machining
Moldavian Journal of the Physical Sciences, 2014 Physico-chemical and adsorption-structural properties of the Cr-Ni alloy product elec- trochemical machining (EM) subjected to thermo treatment within temperature interval 100-950o C are considered.
Zaporojcenco, Anastasia
doaj
Chemical and spectroscopic analysis of olive mill waste water during a biological treatment [PDF]
, 2007 The treatment of olive mill waste water was studied on the laboratory scale. Physico–chemical analyses showed the final products had a mean pH of 5.4 without neutralisation and 5.7 when lime was added to the process.
Hafidi, Mohamed +11 more
core +1 more source
Surface Heat Treatment to Hot-Work Die Steel H13
Teshugang, 2005 The steel H13(4Cr5MoSiV1)-0.32～0.45C,0.80~1.2Si,0.20~0.50Mn,4.75～5.50Cr,1.10~1.75Mo,0.80~1.20V is a hot-work die steel wide used for hot extrusion die and pressure casting die with service temperature up to 600 ℃.The surface low temperature thermo ...
曹光明
doaj
Enhanced performance and reprocessability in polypropylene-lignin blends through plasma treatment
Journal of Bioresources and BioproductsIn this work, a new compatibilization strategy for polypropylene-lignin blends was presented, which did not rely on the use of solvents or other chemicals.
Emanuela Bellinetto +8 more
doaj +1 more source