Results 41 to 50 of about 175 (164)
An Experimental PIV/POD Study on the Sequentially Coupled Flow Field of Swirl and Multiple Jets
The stepwise flow reconstruction induced by sequential coupling of swirl, primary jets, and dilution jets was experimentally investigated in a model combustor using high‐speed PIV and proper orthogonal decomposition (POD). Three nonreacting configurations were compared: pure swirl, swirl plus primary jets, and swirl with both primary and dilution jets.
Qingqing Dong, Jian Chen, Kan Xie
wiley +1 more source
ABSTRACT Perirenal adipose tissue (PRAT) contributes to the maintenance of elevated blood pressure through afferent nerves and serves as an important peripheral, modifiable target for hypertension management. This single‐center, prospective pilot trial assessed the feasibility and safety of a novel focused power ultrasound device for perirenal adipose ...
Yang Hua +15 more
wiley +1 more source
Continuous and explosive synchronization transition in turbulent combustors
Thermoacoustic instabilities in turbulent combustors have disastrous consequences and present notorious challenges in their modeling, prediction, and control.
Samarjeet Singh +4 more
doaj +1 more source
Electrically Driven Supersonic Combustion
This manuscript reviews published works related to plasma assistance in supersonic combustion; focusing on mixing enhancement, ignition and flameholding. A special attention is paid for studies, which the author participated in person.
Sergey B. Leonov
doaj +1 more source
Detached Eddy Simulation (DES) of a Turbulent Premixed Flame Stabilized on a Bluff Body
ABSTRACT As the demand for net‐zero emissions intensifies, low‐emission fuels (LEFs) are increasingly explored for their potential to reduce pollutants in combustion systems. The present study investigates the flame dynamics and pollutant emissions (CO and NOx) of different LEFs using detached eddy simulations (DES), a method that offers better ...
Abdelkader Hemaizia +2 more
wiley +1 more source
This paper proposes an observer‐based adaptive output‐feedback boundary control to stabilize the vibrations of the moving cage of a dual‐cable mining elevator. This system is comprised of two mechanically jointed winding drums that drive the two cables through the floating sheaves to lift the cage.
Elham Aarabi +2 more
wiley +1 more source
Exploring liquid fuel combustion dynamics in a swirl burner using dynamic mode decomposition
Aero gas turbine engine combustors are transitioning from traditional Rich-Quench-Lean (RQL) staging to Lean Premixed Prevaporized (LPP) operation to reduce harmful NOx emissions and improve combustion efficiency.
Alireza Ghasemi, Jim B. W. Kok
doaj +1 more source
Boosting flexible electronics with integration of two‐dimensional materials
The progress was summarized in the flexible electronics empowered by the two‐dimensional materials, including electronic skins (for sweat and temperature sensors), gas sensors, touch pads, nanogenerators for mechanical energy collection, flexible supercapacitors and batteries, transistors and logic circuits, as well as memristors for neuromorphic ...
Chongyang Hou +14 more
wiley +1 more source
Acoustic Design Parameter Change of a Pressurized Combustor Leading to Limit Cycle Oscillations
When aiming to cut down on the emission of nitric oxides by gas turbine engines, it is advantageous to have them operate at low combustion temperatures. This is achieved by lean premixed combustion.
Mehmet Kapucu +2 more
doaj +1 more source
Fluidic Ultrasound Generation for Non‐Destructive Testing
Air‐coupled ultrasound enables material characterization and fault detection for specimens that are very large or do not allow contact with other materials. This study presents a novel fluidic transducer that can withstand harsh environments and generates a high‐amplitude ultrasonic signal without impedance mismatch to air.
Benjamin Bühling +2 more
wiley +1 more source

