Results 61 to 70 of about 702 (177)
Identifying Oscillation‐Vulnerable Buses Using Impedance‐Based Reflection Coefficient
We propose a method to identify oscillation‐vulnerable buses by applying the Barkhausen criterion to an impedance‐based reflection‐coefficient analysis in power systems. The method computes the reflection‐coefficient magnitude and phase from the Thevenin impedance seen from each bus and the corresponding load impedance, and evaluates phase variations ...
Taewan Choi +3 more
wiley +1 more source
To improve the use of lithium-ion batteries in electric vehicle (EV) applications, evaluations and comparisons of different equivalent circuit models are presented in this paper.
Jinxin Fan, Hongwen He, Rui Xiong
doaj +1 more source
ABSTRACT Renewable energy bases in Desert‐Gobi‐Wasteland (DGW) areas connected with high‐voltage direct current (HVDC) transmission systems show notable weak‐grid features, including low inertia, weak damping and a low short‐circuit ratio. This results in strong active power–voltage (P–V) coupling effects, making existing real‐time active power control
Guoqing Li +4 more
wiley +1 more source
Improved MPPT for PV Systems Combining Thevenin Equivalents with Simple Neural Networks
Efficient MPPT (Maximum Power Point Tracking) algorithms are required for PV (Photovoltaic) systems in order to obtain maximum power under temperature and sun irradiation variations.
khessam medjdoub +5 more
doaj +1 more source
A High-Efficiency RF Harvester with Maximum Power Point Tracking
This paper presents the implementation of a high-efficiency radiofrequency (RF) harvester, which consists of a rectenna and a maximum power point tracker (MPPT).
Manel Gasulla +5 more
doaj +1 more source
This study investigates modelling of doubly-fed induction generator (DFIG)-based wind turbines for low-frequency oscillation analysis of power systems with high penetration of distributed energy.
Yunhui Huang +5 more
doaj +1 more source
Optimizing state of charge estimation using thevenin models and extended Kalman filter
Precise battery modeling plays a critical role in enhancing State of Charge (SoC) estimation and optimizing Battery Management Systems (BMS) for electric vehicles and energy storage systems.
Hamza Benhammou +2 more
doaj +1 more source
Using an Evolutionary Algorithm for Harmonic Load Modeling by Norton and Thevenin Equivalents.
The Norton equivalent model for harmonic load modeling is used widely. The parameters of the model are usually calculated analytically. These calculations are based on measured or simulated voltage/current waveforms. In this case, harmonic analysis is needed to obtain the harmonic spectra. After this step, model parameter values are calculated for each
Bilandžija, Domagoj +2 more
openaire +5 more sources
A rapid simulation method for full-bridge sub-module MMC based on bridge arm equivalent capacitance
MMC (modular multilevel converter) contains a large number of switching elements, which brings a huge computational burden to the electromagnetic transient simulation.
LU Yi +6 more
doaj +1 more source
In this paper, advanced equivalent circuit models (ECMs) were developed to model large format and high energy nickel manganese cobalt (NMC) lithium-ion 20 Ah battery cells.
Alexandros Nikolian +6 more
doaj +1 more source

