Results 71 to 80 of about 7,248 (211)
A filter design approach to maximize ampacity of cables in nonsinusoidal power systems [PDF]
This paper presents an optimal design of the C-type passive filters for the effective utilization of the power cables under nonsinusoidal conditions based on maximization of the harmonic derating factor (HDF) of a power cable, where maintaining the load ...
Abdel Aleem, SHE +3 more
core +1 more source
A New Procedure Based on Continuous RTU Measurement to Estimate Multi-port Thevenin Equivalent Circuit Parameters of an External Power System [PDF]
In this paper, a novel method is presented that can accurately estimate the Thevenin equivalent circuit parameters of an external power system by RTUs. The presented method is based on the simultaneous measurements of the desired points in the boundary ...
Nabiollah Ramezani +1 more
doaj
On the construction of a digital transfer function from its real part on unit circle [PDF]
It is shown in this correspondence that the system function H(z) of a linear time invariant (LTI) causal digital filter with real impulse response coefficients can be obtained from the real part of its frequency response HR(ejω) given in the form of a ...
Mitra, S. K., Vaidyanathan, P. P.
core +1 more source
The study presents a shapelet‐based method for short‐term voltage stability assessment in multi‐infeed HVDC systems, directly addressing the challenges of high‐dimensional, nonlinear and time‐varying phenomena intrinsic to modern power grids. By integrating a multi‐timescale interaction mechanism with an interpretable time‐series data mining approach ...
Yubo Sun, Shuqing Zhang, Chao Lu
wiley +1 more source
Radioisotope thermal generator (RTG) power conditioner [PDF]
New regulator: (a) permits operation with high-impedance radioisotope thermal generators at conversion efficiencies typically above 90%; (b) does not require input filtering; (c) eliminates current spiking; and (d) is simple, efficient, and reliable ...
Stacey, W. S.
core +1 more source
This paper builds an admittance model for a DFIG‐STATCOM parallel system. Based on the system, the paper provides a method to optimise the control of the STATCOM, which aims to increase the performance of the system during symmetrical faults .
Wenhao Du +5 more
wiley +1 more source
Application of Fuzzy control algorithms for electric vehicle antilock braking/traction control systems [PDF]
—The application of fuzzy-based control strategies has recently gained enormous recognition as an approach for the rapid development of effective controllers for nonlinear time-variant systems.
Bingham, Chris +3 more
core +1 more source
This paper analyzes the robustness of a current‐controlled quasi‐stationary electrical model virtual synchronous machine. Fundamental limitations of structured singular value‐based stability analysis are revealed for nonlinear converter‐dominated power systems when parametric uncertainties significantly affect the operating point.
Christina Zuromski +3 more
wiley +1 more source
Performance Analysis of a Single-Diode Photovoltaic Model Based on a Thevenin’s Equivalent Circuit
This article proposes a linear Thevenin's equivalent circuit for a single-diode model. The Thevenin's equivalent circuit is derived based on the piecewise linearization for the nonlinear characteristic of the diode.
Ammar AL-GIZI +3 more
doaj +1 more source
A STATIC AND DYNAMIC TECHNIQUE CONTINGENCY RANKING ANALYSIS IN VOLTAGE STABILITY ASSESSMENT [PDF]
The objective of the research is to compare between technique for determine the weak bus of the power system using static and dynamic contingency ranking analysis. Identification of the weak bus is very important for providing
Nizam , Muhammad
core

