Results 1 to 10 of about 143,763 (308)
Materials & Design, 2023 Overheating is almost inevitable during the curing of thick polymer matrix composite parts, which always induces degradation of the mechanical properties.
Yubo Zhou +5 more
doaj +3 more sources
Influence of Composite Thickness on Ultrasonic Guided Wave Propagation for Damage Detection
Sensors, 2022 In this paper, the propagation properties of ultrasonic guided waves (UGWs) in different-thickness composites (i.e., 2, 4 and 9 mm) were critically assessed, and their effectiveness for damage detections and localisations under varying temperatures was ...
Tianyi Feng +2 more
doaj +1 more source
Applied Sciences, 2023 This paper describes a study that focuses on assessing the influence of composites with different thicknesses (2 mm, 4 mm, and 9 mm) on embedded ultrasonic guided waves (UGWs) under varying temperatures.
Tianyi Feng, M. H. Ferri Aliabadi
doaj +1 more source
npj Biofilms and Microbiomes, 2023 Attachment of bacteria onto a surface, consequent signaling, and accumulation and growth of the surface-bound bacterial population are key initial steps in the formation of pathogenic biofilms.
Liyun Wang +14 more
doaj +1 more source
Effects of pyrocarbon interphase on microstructure and properties of C/SiBCN composites
Materials Research Express, 2023 C/SiBCN composites are expected to be widely used in aerospace applications because of their excellent high-temperature stability. However, the interfacial reactions have significantly limited their practical application.
Yan Jia, Haifeng Cheng, Si’an Chen
doaj +1 more source
Sensors, 2020 An effective approach for an embedded piezo diagnostic layer into thick composite material is presented. The effectiveness of the approach is assessed in comparison to the surface-mounted layer.
Tianyi Feng +2 more
doaj +1 more source
Mechanical Properties Evaluation for Cotton/Glass/Epoxy Hybrid Composite
ASM Science Journal, 2022 Natural fibre reinforced composites of any group are essential to satisfy the current demand and to keep the environment-friendly approach. In the present work, an attempt has been made to replace glass fibres partially by cotton fabric so as to reduce ...
Vivek Ramdas Gaval
doaj +1 more source
Scientific Reports, 2022 Titanium matrix composites (TMCs) with TiC reinforcements were fabricated by an in-situ method that evolves pure titanium foils (thick: 100 μm) and graphite powder sheets by spark plasma sintering.
Ning Wang +3 more
doaj +1 more source
Nanocellulose Xerogel as Template for Transparent, Thick, Flame-Retardant Polymer Nanocomposites
Nanomaterials, 2021 Cellulose nanofibers (CNFs) have excellent properties, such as high strength, high specific surface areas (SSA), and low coefficients of thermal expansion (CTE), making them a promising candidate for bio-based reinforcing fillers of polymers. A challenge
Wataru Sakuma +3 more
doaj +1 more source
Materials Research Express, 2022 Al _2 O _3 p/high-manganese steel-matrix composites were successfully fabricated by gravity casting infiltration, with iron powder added in the preforms to adjust the Al _2 O _3 p fraction.
Shaosheng Wei, Dehong Lu
doaj +1 more source