Results 51 to 60 of about 903,821 (297)
Linear and Nonlinear Optical Properties of Mn doped Benzimidazole Thin Films
, 2014 In the present work, the Mn doped benzimidazole (BMZ) thin films were prepared by simple chemical bath deposition technique. The material was directly deposited as thin film on glass substrates and the metal concentration in the solution was varied in ...
Babu, R. Ramesh +3 more
core +1 more source
Pyrosol deposition of anatase TiO2 thin films starting from Ti(OiPr)4/acetylacetone solutions [PDF]
, 2007 TiO2 thin films were deposited on Si(100) and steel substrates by Pyrosol technique. The layer morphology depends on the concentration of titanium tetra-isopropoxide (TTIP) used as molecular precursor in solutions with acetylacetone (Acac).
Abisset, Sidonie +2 more
core +4 more sources
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Nanoscale Research Letters, 2017 Conductance method was employed to study the physics of traps (e.g., interface and bulk traps) in the Al2O3/GaN MOS devices. By featuring only one single peak in the parallel conductance (G p/ω) characteristics in the deep depletion region, one single ...
Yuanyuan Shi +7 more
doaj +1 more source
Crystal orientation and thickness dependence of superconductivity on tetragonal FeSe1-x thin films
, 2009 Superconductivity was recently found in the simple tetragonal FeSe structure. Recent studies suggest that FeSe is unconventional, with the symmetry of the superconducting pairing state still under debate.
Chang, A. M. +9 more
core +1 more source
Characterisation of Thin Films CuIn1-xAlxSe2 Prepared by Selenisation of Magnetron Sputtered Metallic Precursors [PDF]
, 2007 Thin films of CuIn1-xAlxSe2 have been produced by the selenisation of magnetron sputtered Cu/In/Al precursor layers using elemental selenium and the chemical and physical properties of the layers have been determined for different conditions of synthesis.
Forbes, Ian +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Nanoscale Research Letters, 2019 A novel CMOS-process-compatible high-holding voltage silicon-controlled rectifier (HHV-SCR) for electrostatic discharge (ESD) protection is proposed and demonstrated by simulation and transmission line pulse (TLP) testing.
Zhuo Wang +5 more
doaj +1 more source
High quality YBa2Cu3Ox ultra-thin films and Y/Pr/Y multilayers made by a modified RF-magnetron sputtering technique [PDF]
, 1990 High quality ĉ-axis oriented thin and ultra-thin films have been grown in situ on (100) surfaces of ZrO2, SrTiO3 and MgO. Sharp transitions were observed with Tc,zero of 87–91 K for films thicker than 70 Å.
Aarnink, W.A.M. +3 more
core +2 more sources
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source