Results 41 to 50 of about 134,625 (266)
Optimized Conditions for Catalytic Chemical Vapor Deposition of Vertically Aligned Carbon Nanotubes [PDF]
Here, we have synthesized vertically aligned carbon nanotubes (VA-CNTs), using chemical vapor deposition (CVD) method. Cobalt and ethanol are used as the catalyst and the carbon source, respectively.
M. Makenali +5 more
doaj
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink +4 more
wiley +1 more source
High-Uniformity Flat-Top Light Spot Based on a Dielectric Metasurface
With the rapid development of laser processing and infrared imaging, the demand for flat-top beams with high uniformity has become increasingly urgent.
Xinxin Pu +6 more
doaj +1 more source
Effect of Substrate Temperature on Structural and Optical Properties of Nanocrystalline CdTe Thin Films Deposited by Electron Beam Evaporation [PDF]
Nanocrystalline Cadmium Telluride (CdTe) thin films were deposited onto glass substrates using electron beam evaporation technique. The effect of substrate temperature on the structural, morphological and optical properties of CdTe thin films has been ...
M. Rigana Begam +5 more
doaj
High-Performance All-Optical Terahertz Modulator Based on Graphene/TiO2/Si Trilayer Heterojunctions
In this paper, we demonstrate a trilayer hybrid terahertz (THz) modulator made by combining a p-type silicon (p-Si) substrate, TiO2 interlayer, and single-layer graphene. The interface between Si and TiO2 introduced a built-in electric field, which drove
Miaoqing Wei +7 more
doaj +1 more source
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Effect of Annealing on Structural and Optical Properties of Cu Doped In2O3 Thin Films [PDF]
Cu-doped In2O3 thin films were prepared using flash evaporation method at different Cu-doping levels. The effect of annealing was studied on the structure, morphology and optical properties of the thin films.
S. Kaleemulla +5 more
doaj
Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati +11 more
wiley +1 more source
A Deep Learning-Based Preprocessing Method for Single Interferometric Fringe Patterns
A novel preprocessing method based on a modified U-NET is proposed for single interference fringes. The framework is constructed by introducing spatial attention and channel attention modules to optimize performance.
Xueliang Zhu +5 more
doaj +1 more source

