Results 51 to 60 of about 265,797 (310)

Experimental and Numerical Studies on Preparation of Thin AZ31B/AA5052 Composite Plates Using Improved Explosive Welding Technique

Metals, 2020
In this work, an improved explosive welding technique was investigated to fabricate a thin Mg/Al plate, where an additional thin aluminum sheet was used as a buffer layer between the explosive and the Al plate, and the Mg plate was rigidly constrained by
Qi Wang, Xuejiao Li, Biming Shi, Yong Wu
doaj   +1 more source

Time‐restricted feeding prior to Mycobacterium tuberculosis infection reduces tissue CD4+ T cells with limited impact on bacterial clearance

FEBS Open Bio, EarlyView.
Time‐restricted feeding (TRF) in mice increased liver fatty acid oxidation and decreased fatty acid biosynthesis. These alterations persisted when TRF was discontinued and the host was infected with Mycobacterium tuberculosis. Pre‐exposure to TRF did not alter tissue (lung and spleen) mycobacterial burden but significantly reduced CD3+ T cells in lungs
Ashish Gupta, Nidhi Yadav, Subhasmita Das, R. Rajendra Kumar Reddy, Nupur Sharma, Amol Ratnakar Suryawanshi, Jaswinder Singh Maras, Ranjan Kumar Nanda   +7 more
wiley   +1 more source

Transient vibration analysis of a completely free plate using modes obtained by Gorman's superposition method

, 2010
This paper shows that the transient response of a plate undergoing flexural vibration can be calculated accurately and efficiently using the natural frequencies and modes obtained from the superposition method.
Ilanko, Sinniah, Yusuke, Mochida
core   +1 more source

A new flow chip in combination with multiphoton microscopy as a protocol for longitudinal 3D imaging of tissue calcification under shear stress

FEBS Open Bio, EarlyView.
Miniaturized flow chip platform enabling continuous perfusion and longitudinal multiphoton 3D imaging of vascular smooth muscle cell constructs under physiological flow. Brightfield imaging guides region selection, while CellTracker Green and mRuby‐labeled fetuin‐A visualize cells and mineral deposition, respectively. Magnesium supplementation markedly
Vytautas Kučikas, Aaron D. Morgan, Ignas Čiurlionis, Christian Böhm, Stefan Jockenhövel, Willi Jahnen‐Dechent, Marc A. M. J. van Zandvoort   +6 more
wiley   +1 more source

Effect of Chloride on Tensile and Bending Capacities of Basalt FRP Mesh Reinforced Cementitious Thin Plates under Indoor and Marine Environments

International Journal of Polymer Science, 2016
This paper presented a durability experimental study for thin basalt fiber reinforced polymer (BFRP) mesh reinforced cementitious plates under indoor and marine environment.
Yan Xie, Kunhua Guan, Lin Lai
doaj   +1 more source

Derivation of losses from impedance spectrum for contour modes of ceramic resonator

Journal of Asian Ceramic Societies, 2020
Method of loss coefficients calculation from mechanical quality factors of transversal vibration modes is presented. Theoretical formulae are derived for the contour mode of thin square plate and width extensional mode of a thin rectangular plate ...
Jiří Erhart, Vijay Bijalwan, Filip Solař, Karel Maca   +3 more
doaj   +1 more source

Rapid evaluation of radial basis functions

, 2005
Over the past decade, the radial basis function method has been shown to produce high quality solutions to the multivariate scattered data interpolation problem.
Baxter, Brad J.C., Roussos, George, Brad J.C. Baxter, George Roussos   +3 more
core   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

Advanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi, Pasquale Guglielmi, Gianfranco Palumbo, Giuseppe Carbone   +3 more
wiley   +1 more source

Laser transfer of sol-gel ferroelectric thin films using an ITO release layer [PDF]

, 2011
A new laser transfer process is reported which allows damage-free transfer of ferroelectric thin films from a growth substrate directly to a target substrate.
Bansal, A., D. Bhattacharyya, Yeatman, E. M., A. Bansal, R.V. Wright, Bhattacharyya, Debabrata, P.B. Kirby, G. Dou, Dou, G., A.S. Holmes, Hergert, R., E.M. Yeatman, R. Hergert, Holmes, A. S., Wright, Robert V., Kirby, Paul B.   +15 more
core   +1 more source

Carboxylic‐Acid Functionalized Multiwalled Carbon Nanotube‐Alkane‐Based Resistive Temperature Sensor for Cold Chain Applications

Advanced Engineering Materials, EarlyView.
This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera, Philippe Marrec, A. Jorge Parola, Madalena Dionísio, Hugo Águas, Andreia F. M. Santos, Hamed Pourkheirollah, Donald Lupo, César A. T. Laia   +8 more
wiley   +1 more source