Results 101 to 110 of about 448,058 (217)
ABSTRACT Objective Early risk stratification may support clinical decision‐making in spontaneous intracerebral hemorrhage (ICH). We aimed to develop and internally validate HAGIV, a score integrating frequency of imaging markers (FIM), a time‐adjusted non‐contrast computed tomography (CT) metric of hematoma expansion, with established predictors for 90‐
Lei Song +10 more
wiley +1 more source
Objective The study aimed to identify symptom‐based predictors of dry eye disease (DED) signs in the Sjögren's International Collaborative Clinical Alliance (SICCA) cohort. Methods We performed a retrospective analysis examining 16 ocular symptoms (most graded 0–4) and artificial tear (AT) use (graded 0–3) as predictors of DED signs (abnormal ocular ...
Pragnya R. Donthineni +7 more
wiley +1 more source
Objective To investigate the association between rheumatoid arthritis (RA) and coronary artery calcium (CAC) prevalence, incidence, and progression over four years in adults without prior cardiovascular disease. Methods A case‐cohort study within the Brazilian Longitudinal Study of Adult Health (ELSA‐Brasil) included 585 participants (86 patients with ...
Patrícia Fonseca Estrada +7 more
wiley +1 more source
This article proposes a convergent adaptive observer for a damped wave PDE and an infinite‐dimensional ODE coupled in cascade using sampled‐in‐space ODE state measurements. The proposed observer estimates the distributed states of the PDE and ODE along with unknown PDE parameters and spatial input.
Zehor Belkhatir +2 more
wiley +1 more source
Predicting extreme defects in additive manufacturing remains a key challenge limiting its structural reliability. This study proposes a statistical framework that integrates Extreme Value Theory with advanced process indicators to explore defect–process relationships and improve the estimation of critical defect sizes. The approach provides a basis for
Muhammad Muteeb Butt +8 more
wiley +1 more source
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Some new regularity criterion for MHD three-dimensional flow
The aim of the paper is to establish regularity criteria for the weak solution of fluid passing through the porous media in R^{3}.
Saeed ur Rahman +2 more
doaj
This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
Fluid Deformation in Random Steady Three Dimensional Flow. [PDF]
Lester DR +3 more
europepmc +1 more source

