Results 41 to 50 of about 19,035 (289)
Improving the performance of concrete using 3D fibres
, 2012 This paper examines whether 3D fibre reinforcement can improve the toughness and flexural strength of concrete, when compared to equal dosage of straight steel fibres. This work was carried out to determine structural qualities that may lead to potential
Richardson, Alan, Heather, Marcus
core +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing provides precise control over the placement of continuous fibres within polymer matrices, enabling customised mechanical performance in composite components. This article explores processing strategies, mechanical testing, and modelling approaches for additive manufactured continuous fibre‐reinforced composites.
Cherian Thomas, Amir Hosein Sakhaei
wiley +1 more source
, 2016 Influence of moisture absorption/desorption on the flexural properties of Glass-fibre-reinforced polymer (GFRP) laminates was experimentally investigated under hot/wet aging environments.
Qiang, X. (author) +9 more
core +2 more sources
Comparative study of physical properties of zirconia based dental ceramics [PDF]
, 2009 The aim of this project was to evaluate and compare the mechanical properties of commercial yttria partially stabilized tetragonal zirconia polycrystalline (Y-TZP) ceramics, which have generated interest in restorative dentistry because of their high ...
Pittayachawan, P, Pittayachawan, P.
core
Experimental Characterization of Mycelium‐Based Composites Under Multiple Loading Conditions
Advanced Engineering Materials, EarlyView.This study examines the mechanical response of mycelium‐based composites under compression, shear, and tension using mechanical testing and imaging methods. The comparison between unpressed and hot‐pressed specimens shows that hot pressing is associated with higher compression and shear stiffnesses.
Shaghayegh Elahi +5 more
wiley +1 more source
An In vitro Comparative Evaluation of Flexural Strength of Monolithic Zirconia after Surface Alteration Utilising Two Different Techniques [PDF]
Journal of Clinical and Diagnostic Research, 2017 Introduction: Chairside surface alteration like grinding is often done by clinicians for adjustment of zirconia restorations. To restore the surface of the prostheses, either polishing or glazing is done.
Ketaki Janardhan Chougule +1 more
doaj +1 more source
Compósito reforçado com fibra de vidro pré-tracionada: influência da protensão nas propriedades flexurais [PDF]
, 2007 Dissertação (mestrado) - Universidade Federal de Santa Catarina, Centro de Ciências da Saúde. Programa de de Pós-Graduação em Odontologia.O objetivo deste estudo foi avaliar a influência da protensão nas propriedades flexurais de duas resinas compostas ...
Schlichting, Luís Henrique
core
Advanced Engineering Materials, EarlyView.This article presents an experimental and numerical modal investigation of composite sandwich structures using surfboards as model systems. By comparing different core materials and reinforcement strategies, the study demonstrates how local stiffeners influence vibrational response and introduce characteristic modal features, highlighting modal ...
Brett Connellan +4 more
wiley +1 more source
Influence of Flexural Testing Parameters on the Flexural Response of Ultra-High-Performance Concrete
BuildingsThis study investigates the differences in flexural behavior of ultra-high-performance concrete (UHPC) arising from variations in test methods and key experimental parameters.
Seong-Jin Woo +3 more
doaj +1 more source
Assessing influence of active and passive confinement on flexural behaviour of CFST beams
Građevinar, 2019 The aim of this study is to investigate the effect of active and passive confinement on the flexural behaviour of concrete-filled steel tubes. Three-point flexural test is carried out on twelve confined specimens.
Morteza Naghipour +3 more
doaj +1 more source