Results 131 to 140 of about 5,139 (184)

Effect of Deposition Parameters on Micromechanical Properties and Machining Performance of CrN Coating for Wet Finish Turning of Ti6Al4V Alloy. [PDF]

Materials (Basel)
Chowdhury MSI, Bose B, Akter S, Veldhuis SC.   +3 more
europepmc   +1 more source

A Robust Design approach for error reduction in Thermoelastic Stress Analysis on Ti6Al4V alloy in presence of unknow biaxial residual stresses. [PDF]

Heliyon
Di Carolo F, Galietti U.
europepmc   +1 more source

Finite Element Simulation and Microstructural Evolution Investigation in Hot Stamping Process of Ti6Al4V Alloy Sheets. [PDF]

Materials (Basel)
Qu M, Gu Z, Li X, Wang J, Yu G, Yi L.
europepmc   +1 more source

Effects of Shot Peening and Electropolishing Treatment on the Properties of Additively and Conventionally Manufactured Ti6Al4V Alloy: A Review. [PDF]

Materials (Basel)
Okuniewski W, Walczak M, Szala M.
europepmc   +1 more source

On Strain-Hardening Behavior and Ductility of Laser Powder Bed-Fused Ti6Al4V Alloy Heat-Treated above and below the β-Transus. [PDF]

Materials (Basel)
Cerri E, Ghio E.
europepmc   +1 more source

Deciphering Hydrogen Embrittlement Mechanisms in Ti6Al4V Alloy: Role of Solute Hydrogen and Hydride Phase. [PDF]

Materials (Basel)
Nguyen TD, Singh C, Lee DH, Kim YS, Lee T, Lee SY.   +5 more
europepmc   +1 more source

Application of non-ionic liquids-based modified dielectrics during electric discharge machining (EDM) of Ti6Al4V alloy to enhance machining efficiency and process optimization. [PDF]

Sci Rep
Farooq MU, Tlija M, Ali S, Khan A, Adediran AA.   +4 more
europepmc   +1 more source

Innovative plasma spray coating of HA-Ti-MgO composite on Ti₆Al₄V alloy for enhanced performance. [PDF]

J Mater Sci Mater Med
Nadian N, Nourouzi S, Jamshidi Aval H.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Low temperature anelasticity in Ti6Al4V alloy and Ti6Al4V–SiCf composite

Materials Science and Engineering: A, 2009
Abstract Internal friction and dynamic Young modulus measurements have been performed in the temperature range 80–350 K on the Ti6Al4V alloy and a Ti6Al4V–SiC f composite reinforced by unidirectional SiC fibers (SCS-6). A vibrating reed apparatus operating at low strain amplitude ( −5 ) in the frequency range 10 2 –10 4  Hz was employed.
AMADORI, STEFANO, BONETTI, ENNIO, PASQUINI, LUCA, P. Deodati, R. Donnini, R. Montanari, C. Testani   +6 more
openaire   +3 more sources