Results 11 to 20 of about 1,836,983 (261)

In vivo analysis of the effects of CoCrMo and Ti particles on inflammatory responses and osteolysis [PDF]

open access: yesRSC Adv, 2018
CoCrMo particles induced a more severe inflammatory response and greater osteolysis than Ti particles in vivo in mice.
Juehong Li   +5 more
core   +2 more sources

Interface Structure and Mechanical Properties of 7075Al Hybrid Composite Reinforced with Micron Ti Metal Particles Using Pressure Infiltration

open access: yesMetals, 2019
Micron Ti metal particles were incorporated into SiCp/7075Al composites using pressure infiltration. The interface structure between the Ti metal particles and the matrix during the casting processes were investigated.
Yixiong Liu   +5 more
doaj   +2 more sources

The microstructures and mechanical properties of low-cost Ti particles reinforced AZ81 composites

open access: yesJournal of Materials Research and Technology
Compared to conventional ceramic particle-reinforced Mg composites, incorporating Ti particles into the Mg molten melt poses greater difficulty due to their significantly higher density compared to Mg.
Gong Chen   +9 more
doaj   +2 more sources

Effect of Ti particles on microstructure and mechanical properties of TiP/AZ91 composites

open access: yesJournal of Materials Research and Technology, 2023
Ti particles (5 wt%) reinforced AZ91 Mg matrix composites (TiP/AZ91 composites) were prepared by powder metallurgy. As a result, the strength and ductility of TiP/AZ91 composites were improved compared with AZ91 alloy.
Dongmei Pu   +7 more
doaj   +1 more source

Nanocrystalline M-type hexaferrite powders: preparation, geometric and magnetic propertiess [PDF]

open access: yes, 1994
Co-Ti-Sn-Ge substituted M-type bariumhexaferrite powders with mean grain sizes between about 10 nm and about 1 ¿m and a narrow size distribution were prepared reproducibly by means of a modified glass crystallization method.
Gornert, P.   +29 more
core   +2 more sources

Hybridizing micro-Ti with nano-B4C particulates to improve the microstructural and mechanical characteristics of Mg–Ti composite

open access: yesJournal of Magnesium and Alloys, 2014
In this study, the effects of hybridizing micron-sized titanium particles with nano-sized boron carbide particles on the microstructural and mechanical properties of Mg–Ti composite were investigated.
S. Sankaranarayanan   +2 more
doaj   +1 more source

In Situ Formation of Al3Ti and Its Effects on the Microstructure, Hardness and Tribological Properties of Al Matrix Composites with Various Ti Contents

open access: yesCrystals, 2023
At present, Al matrix composites (AMCs) have drawn much attention owing to their light weight, high specific strength, high thermal conductivity, and superior excellent wear resistance, which endows them with great potential in the aerospace, automobile ...
Fei Lin   +6 more
doaj   +1 more source

Shape-Controlled TiCx Particles Fabricated by Combustion Synthesis in the Cu-Ti-C System

open access: yesCrystals, 2017
TiCx particle-reinforced Cu-matrix composites were prepared in the Cu-Ti-C system by thermal explosion and hot press. Extracted TiCx particles with various shapes of in situ TiCx particles in the Cu-Ti-C system were observed through the Field Emission ...
Dongdong Zhang   +5 more
doaj   +1 more source

The introduction of SiC into Cu melts based on Ti–SiC system and its transformation

open access: yesJournal of Materials Research and Technology, 2020
In this work, SiC particles with different sizes have been effectively introduced into Cu melts based on Ti–SiC system, and the types and microstructures of Ti–SiC reaction products are varied with the SiC size change. With small size, SiC can absolutely
Qing Liu   +5 more
doaj   +1 more source

Fine Particles of Ti and Ti-Mo Alloy Prepared by Gas Evaporation [PDF]

open access: yes, 1990
Fine particles of Ti-Mo alloy were prepared by evaporation. When Ti-40at % Mo alloy was evaporated on tungsten filament, fine particles of Ti contaminated with W were obtained. These particles were polyhedron in shape and 10~250nm in diameter.
Umemoto, Masayuki   +3 more
core   +1 more source

Home - About - Disclaimer - Privacy