Results 201 to 210 of about 1,543 (213)

Influences of coating thickness on cutting temperature for dry hard turning Inconel 718 with PVD TiAlN coated carbide tools in initial tool wear stage

Journal of Manufacturing Processes, 2020
Jinfu Zhao, Zhanqiang Liu
exaly  

Tribological properties of nanostructured TiAlN/W2N multilayer coating produced by PVD

Wear, 2019
Fenghua Su
exaly  

Optimization of Tialn Coatings by Y-Addition and Multilayer Architecture

Journal of Alloys and Compounds
Ye H. Long, Jia J. Li, Li Chen, Jing Zhong, Li J. Zhang   +4 more
openaire   +1 more source

Influence of a TiAlN coating on the mechanical properties of a heat resistant steel at room temperature and 650 °C

Journal Wuhan University of Technology, Materials Science Edition, 2013
Chengyu Zhang, Shengru Qiao
exaly  

Temperature dependent friction and wear of magnetron sputtered coating TiAlN/VN

Wear, 2011
Quanshun Luo
exaly  

Characterization and Corrosion Studies of TiAlN PVD Coating by Using the Polarization Test Method

Journal of Bio- and Tribo-Corrosion, 2019
Vijayasarathi Prabakaran
exaly  

Wear Behavior of Cryogenically Treated TiAlN, TiAlN/TiN, and TiAlN/AlCrN Coated Tools during End Milling of XH67MBTHO

Journal of Materials Engineering and Performance
Jayaram C. Sasi, Jose Mathew
openaire   +1 more source

Influences of Sedimentation Time and Target Current Ratio on Wear Resistance of a Magnetron Sputtered TiAlN Coating

Rare Metal Materials and Engineering, 2016
Tang Yong, Lu Longsheng
exaly  

Microstructural and tribological characterisation of a nitriding/TiAlN PVD coating duplex treatment applied to M2 High Speed Steel tools

Surface and Coatings Technology, 2015
J G Partridge, D G Mcculloch, E D Doyle
exaly  

Multylayer doped nitride coatings of the tialn system

The results of studies of the range of multilayer nanostructured coatings based on the TiAlN system - structural state, morphology, composition, and microgeometry of the interface - are presented. A coating with a total thickness of 7-8 μm and a layer thickness (TiAlN/CrN) of 20-30 nm was applied by the vacuum arc method to a base of superhard ceramics
openaire   +1 more source