Novel electroblowing synthesis of tin dioxide and composite tin dioxide/silicon dioxide submicron fibers for cobalt(ii) uptake. [PDF]
Calcination temperature and heating rate markedly affected the structure and morphology of electroblown SnO2/SiO2composite fibers. Compared with bare SnO2fibers, the SiO2component improved the mechanical strength but slightly weakened Co2+uptake.
Paajanen J +8 more
europepmc +5 more sources
Crystalline Mesoporous F-Doped Tin Dioxide Nanomaterial Successfully Prepared via a One Pot Synthesis at Room Temperature and Ambient Pressure. [PDF]
We report the successful one pot synthesis of crystalline mesoporous tin dioxide powder doped with fluoride at ambient pressure and temperature. This material possesses a high surface area, narrow pore size distribution, small average crystallite sizes ...
Aqeel T, Greer HF.
europepmc +2 more sources
Weak Localization in Polycrystalline Tin Dioxide Films. [PDF]
The electrical and magnetotransport properties of nanocrystalline tin dioxide films were studied in the temperature range of 4–300 K and in magnetic fields up to 8 T. SnO2−δ films were fabricated by reactive direct current (DC) magnetron sputtering of a tin target with following 2 stage temperature annealing of synthesized samples.
Ksenevich V +4 more
europepmc +7 more sources
A Facile Method to Incorporate Di-Dopant Elements (F and Sb) into Crystalline Mesoporous Tin Dioxide Nano Powder at Ambient Temperature and Pressure. [PDF]
A simple two step synthetic method for di‐doped crystalline mesoporous tin dioxide powder containing antimony and fluoride at ambient pressure and temperature has been developed.
Aqeel T, Greer HF.
europepmc +2 more sources
50 eV O+ ion induced deposition of tin dioxide using tetramethyltin. [PDF]
The aim of the present study was to deposit tin oxide films on Si wafers or quartz crystal microbalance plates acting as substrates, using low-energy ion beams. The substrates were held at ambient temperature and two different methods were employed.
Yoshimura S, Takeuchi T, Kiuchi M.
europepmc +2 more sources
Pulsed Electrochemical Synthesis and Characterization of Tin Sulfide-Tin Dioxide Nanocomposites
In this paper, tin sulfide-tin dioxide nanocomposites were synthesized by the pulsed-current electrochemical method on the surface of tin substrate in Na2S solution.
Hassan Karami +2 more
openaire +3 more sources
Preparation of V2O5 and SnO2 Nanoparticles and Their Application as Pollutant Removal [PDF]
Vanadium pentoxide and Tin dioxide nanoparticles were prepared by hydrothermal methods to remove methylene blue (MB) and bromothymol blue (BTB) dyes). First the prepared nanoparticles were heated at different temperature (90 oC and 500 oC).
Zahra Hassan, Rashed Rasheed
doaj +1 more source
IR spectral manifestation of tin impurity sites in titanium dioxide
It is known that titanium dioxide as photocatalyst has significant drawback - limited absorption spectrum in the ultraviolet region makes it impossible to use solar energy. To expands the absorption spectrum of TiO2, the doping of impurities (metal, non-
O. V. Smirnova +6 more
doaj +1 more source
SnO2-Based Porous Nanomaterials: Sol-Gel Formation and Gas-Sensing Application
Porous nanocomposites using two (tin dioxide–silica dioxide) and three (tin dioxide–indium oxide-silica dioxide)-component systems for gas sensors were created with the sol–gel method.
Irina Kononova +2 more
doaj +1 more source
Quantum chemical simulation of acid-base properties of the surface of SnO2 nanoparticles
Molecular models for tin dioxide nanoparticles containing 1-7 metal atoms and coordinated or constitutive water have been constructed. Dependent on the composition of the models, the coordination number of the tin atom varied from 4 to 6, and that of ...
O. V. Filonenko +3 more
doaj +1 more source

