Results 1 to 10 of about 1,229,512 (167)
The Tool Life and Coating-Substrate Adhesion of AlCrSiN-Coated Carbide Cutting Tools Prepared by LARC with Respect to the Edge Preparation and Surface Finishing [PDF]
Micromachines, 2020 Nanocomposite AlCrSiN hard coatings were deposited on the cemented carbide substrates with a negative substrate bias voltage within the range of −80 to −120 V using the cathodic arc evaporation system.
Tomáš Vopát +4 more
doaj +2 more sources
POSSIBILITY FOR IMPROVING THE PROPERTIES OF THE PLASTIC MOULD TOOL IN ORDER TO INCREASE ITS SERVICE LIFE [PDF]
European Journal of Materials Science and Engineering, 2022 Injection moulding of grain-reinforced and fibre-reinforced polymers exposes the injection moulding tool to severe wear. The microstructure of the tool affects its hardness, wear resistance and the tool life. In this work were studied two different heat
László TÓTH, Enikő Réka FÁBIÁN
doaj +1 more source
Jin'gangshi yu moliao moju gongcheng, 2023 The preparation of a high-performance hard coating on the surface of a carbide PCB (Printed Circuit Board) milling cutter can address the issue of rapid tool wear during cutting.
Xiaofan YANG +5 more
doaj +1 more source
Experimental study on turning machine with permanent magnetic cutting tool
Open Chemistry, 2022 Implementing a magnetic field on the cutting area during the machining process is one of the ways to increase tool life, as a result, reducing the machining cost. Due to this, numerous researchers conducted various studies in that field.
Kaplan Seyit, Cakir Orhan, Altan Erhan
doaj +1 more source
Machines, 2022 The drilling process in real production places ever-increasing demands on the length and accuracy of the holes made. The drilling of holes beyond a length-to-diameter ratio of 5–10 is called deep drilling.
Martin Pollák +4 more
doaj +1 more source
Machines, 2023 This article uses dimensional analysis to formulate the tool life in the turning process of metal cutting for small-lot production by considering the impacts of the most important parameters.
Sara M. Bazaz +3 more
doaj +1 more source
Appendix to rationally designing of machine tools for example of universal lathe [PDF]
Tehnika, 2015 In this paper, for the universal machine tool for turning and function of the thrust of the cutting speed for blasting area efficiency and stability of the tool and sectional filings.
Pejović Branko B. +4 more
doaj +1 more source
Application of Nanofluids for Machining Processes: A Comprehensive Review
Nanomaterials, 2022 According to the demand of the present world, as everything needs to be economically viable and environment-friendly, the same concept applies to machining operations such as drilling, milling, turning, and grinding. As these machining operations require
Aoha Roohi Amin +2 more
doaj +1 more source
Metals, 2022 This work studies the process feasibility of milling a metal-matrix composite based on Inconel 625 with added NiTi-TiB2 fabricated by direct laser deposition.
Alexey Arlyapov +6 more
doaj +1 more source
Technological Parameter Optimization of Disc-Milling Grooving of Titanium Alloy Based on Grey Correlation Degree [PDF]
Xibei Gongye Daxue Xuebao, 2018 In present paper, aim to some problems such as big material removal rate, serious tool wear and obvious plastic deformation during disc-milling grooving, the orthogonal experiment with three factors and three levels was designed.
doaj +1 more source