Results 41 to 50 of about 4,614,192 (209)
Evaluation of tool edge wear during turning with applying the Fractal Dimension
Mechanical Engineering Journal, 2016 Conventionally, the evaluation of wear in the cutting tools have been focused mainly on the rake and flank face, but there is little research (consideration) that paid attention to the cutting edge of the tools. The reason for this is the cutting edge is
Yuzairi ABDUL RAHIM +2 more
doaj +1 more source
Tool Life of PM-HSS Cutting Tools when Milling of Titanium Alloy [PDF]
, 2017 Machining of titanium alloys meets with poor life of a cutting tool. It is caused by a low thermal conductivity and by a high strength-to-weight ratio of the alloys. Various approaches for cost-effective and productive machining titanium alloys are still
Bach P., Trmal G., Zeman P.
core
Assisted assignment of automotive safety requirements [PDF]
, 2013 ISO 26262, a functional-safety standard, uses Automotive Safety Integrity Levels (ASILs) to assign safety requirements to automotive-system elements. System designers initially assign ASILs to system-level hazards and then allocate them to elements of ...
Araújo, Rui Esteves +4 more
core +1 more source
Fundamental research on hobbing considering environment (Influence of various coating films)
Nihon Kikai Gakkai ronbunshu, 2015 This paper presents tool life (flank wear) and crater wear of four kinds of coated high-speed steel tools and finished surface roughness in hobbing under the conditions of considering environment.
Hironori MATSUOKA +7 more
doaj +1 more source
Simulation modeling of tool delivery system in a machining line [PDF]
, 2011 This paper describes an industrial project aiming to enhance the existing simulation modeling suites used at a car engine factory in the UK. The company continues to enhance its simulation modeling capabilities towards so called the `total plant modeling'
Ladbrook, J., Tjahjono, Benny
core +1 more source
MachinesInconel 718 is a Ni-based superalloy with excellent corrosion resistance, heat resistance, high-temperature strength and high creep resistance. It is also known to be a difficult-to-machine material.
Kazumasa Kawasaki
doaj +1 more source
Machinability analysis of microstructures in pre-hardening plastic mold steel 718
工程科学学报, 2020 Owing to strict dimension accuracy demands, pre-hardening treatment has been widely used in the mold for production of large plastic parts. However, the large volume of mold leads to the existence of tempered martensite and bainite structure on the cross
Yu-bin WANG +3 more
doaj +1 more source
Conceptualising the impact of information asymmetry on through-life cost: case study of machine tools sector [PDF]
, 2018 Information asymmetry (IA) in terms of contextual variety and importance is one of the most challenging aspects of through-life costing in product-service systems (PSS).
Erkoyuncu, J. +6 more
core +2 more sources
Development of partially Ni-coated diamond abrasives for electroplated tools
Nihon Kikai Gakkai ronbunshu, 2014 Electroplated diamond tools are developed for grinding hard and brittle materials because of its low wear resistance. To improve the grinding performance of diamond tools, a single layer of diamond abrasives is electroplated on the tool body.
Yu ZHANG, Yasuhiro TANI, Junji MURATA
doaj +1 more source
Life Beyond the Mailbox: A Cross-Tool Perspective on Personal Information Management [PDF]
, 2002 Email interfaces provide poor support for the personal information management (PIM) activities that users have adopted them for. This paper reports a user study that highlights how two aspects of PIM, information management and task management, cut ...
Boardman, R, Sasse, MA, Spence, R
core