Results 21 to 30 of about 3,385,091 (237)
Topology Driven Improvement of FDC Build Parameters [PDF]
, 1998 The likeliest failure origin for advanced ceramics parts, prepared by fused deposition, is a void from improper fill. Adequate filling of each cross-section is dependent upon the deposition toolpath.
Chard, Jeffrey A. +3 more
core +1 more source
Mechanical Engineering Journal, 2023 A general design method for roller paths for multipass conventional spinning has not been established yet. The roller paths in a production site are often decided by experienced spinners by trial and error.
Shiori GONDO, Hirohiko ARAI
doaj +1 more source
A continues multi-material toolpath planning for tissue scaffolds with hollowed features [PDF]
, 2011 This paper presents a new multi-material based toolpath planning methodology for porous tissue scaffolds with multiple hollowed features. Ruled surface with hollowed features generated in our earlier work is used to develop toolpath planning.
Bahattin Koc +7 more
core +1 more source
Corner Transition Toolpath Generation Based on Velocity-Blending Algorithm for Glass Edge Grinding
Chinese Journal of Mechanical Engineering, 2019 Sharp corners usually are used on glass contours to meet the highly increasing demand for personalized products, but they result in a broken wheel center toolpath in edge grinding.
Kun Ren +5 more
doaj +1 more source
Virtual and Physical Prototyping, 2023 The advents in continuous fibre-reinforced polymer additive manufacturing (CFRP-AM) present unprecedented opportunities for the rapid development of next-generation high-performance composites with selectively and spatially distributed reinforcement ...
Guoquan Zhang +5 more
doaj +1 more source
Implementation and Evaluation of Novel Buildstyles in Fused Deposition Modeling (FDM) [PDF]
, 1999 Previous investigations have shown that the optimization of extrusion dynamics in .conjunction with the buildstyle pattern is of paramount importance to increase part quality in Fused Deposition Modeling (FDM).
Jayal, Anshu Dhar +2 more
core +1 more source
3D Surface Generation Algorithm Using Lagrange Basis Functions in CAD/CAM Application [PDF]
Engineering and Technology Journal, 2008 The objective of this paper is to create an efficient and accurate 3D surfaceinterior data depending on primary initial data based on Lagrangian interpolationconcept.
Akeel S. Bedan, Tahseen F. Alani
doaj +1 more source
From 3D Models to 3D Prints: an Overview of the Processing Pipeline [PDF]
, 2017 Due to the wide diffusion of 3D printing technologies, geometric algorithms for Additive Manufacturing are being invented at an impressive speed. Each single step, in particular along the Process Planning pipeline, can now count on dozens of methods that
Attene, Marco +4 more
core +5 more sources
Bioadditive manufacturing of hybrid tissue scaffolds for controlled release kinetics [PDF]
, 2012 Development of engineered tissue scaffolds with superior control over cell-protein interactions is still very much infancy. Advancing through heterogeneous multifold scaffolds with controlled release fashion enables synchronization of regenerating tissue
Khoda, AKMB +2 more
core +1 more source
Multi-function based modeling of 3D heterogeneous wound scaffolds for improved wound healing [PDF]
, 2010 This paper presents a new multi-function based modeling of 3D heterogeneous porous wound scaffolds to improve wound healing process for complex deep acute or chronic wounds.
Koc, Bahattin +3 more
core +2 more sources