Results 81 to 90 of about 659,176 (294)
Annals of Clinical and Translational Neurology, EarlyView.ABSTRACT Objective Considerable efforts have been dedicated to developing effective treatments for post‐stroke executive impairment (PSEI), among which repetitive transcranial magnetic stimulation (rTMS) has shown great potential. This study aimed to investigate the therapeutic effects of high‐frequency rTMS on working memory (WM) and response ...
Mengting Lao +6 more
wiley +1 more source
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Advanced Engineering Materials, EarlyView.Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
Large deviation principle and inviscid shell models [PDF]
, 2009 A LDP is proved for the inviscid shell model of turbulence. As the viscosity coefficient converges to 0 and the noise intensity is multiplied by the square root of the viscosity, we prove that some shell models of turbulence with a multiplicative ...
Bessaih, Hakima, Millet, Annie
core +9 more sources
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
On Diagnosis of Forwarding Plane via Static Forwarding Rules in Software Defined Networks
, 2013 Software Defined Networks (SDN) decouple the forwarding and control planes from each other. The control plane is assumed to have a global knowledge of the underlying physical and/or logical network topology so that it can monitor, abstract and control ...
Kokten, Koray +2 more
core +1 more source
Optimal Control of Switching Topology Networks [PDF]
Mathematical Problems in Engineering, 2014 We present an extension of a previously proposed approach based on the method of moments for solving the optimal control problem for a switching system considering now a continuous external input. This method is based on the transformation of a nonlinear, nonconvex optimal control problem, into an equivalent optimal control problem with linear and ...
Eduardo Mojica-Nava +3 more
openaire +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Tracking control for multi-agent consensus with an active leader and variable topology
, 2007 In this paper, we consider the coordination control of a group of autonomous mobile agents with multiple leaders. Different interconnection topologies are investigated.
Fax +10 more
core +1 more source
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source