Results 91 to 100 of about 587,715 (334)
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
On the torsion of Brieskorn modules of homogeneous polynomials
Let $f\in \mathbb{C}[X_1,..., X_n]$ be a homogeneous polynomial and B(f) be the corresponding Brieskorn module. We describe the torsion of the Brieskorn module B(f) for n=2 and show that any torsion element has order 1.
Shabbir, Khurram
core +4 more sources
One edge of an elastic rod is inserted into a friction-less and fitting socket head, whereas the other edge is subjected to a torque, generating a uniform twisting moment. It is theoretically shown and experimentally proved that, although perfectly smooth, the constraint realizes an expulsive axial force on the elastic rod, which amount is independent ...
Bigoni, Davide +3 more
openaire +4 more sources
Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio
This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov +4 more
wiley +1 more source
The problem of torsion of a bar with circular cross-section is considered. The bar is made of the material with a stress-strain diagram having the falling branch describing the softening state.
Valery V Struzhanov, Elena A Bakhareva
doaj
Center of Rigidity and Center of Shear in Wall-Frame Systems
In case of torsion in buildings, additional earthquake forces affect the structure and internal forces and displacements increases. For this reason, it is important to place the bearing systems in the plan as much as possible to reduce the torsion effect.
Kanat Burak Bozdoğan, Süleyman Aydın
doaj +1 more source
Dynamical torsion in view of a distinguished class of Dirac operators [PDF]
In this paper we discuss geometric torsion in terms of a distinguished class of Dirac operators. We demonstrate that from this class of Dirac operators a variational problem for torsion can be derived similar to that of Yang-Mills gauge theory.
Juergen, Tolksdorf
core
Effective Potential for the Conformal Sector of Quantum Gravity with Torsion
The effective potential which describes the conformal dynamics of quantum gravity with torsion is discussed. The phase transitions induced by the combination of torsion and curvature are investigated.
Antoniadis +29 more
core +1 more source
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source

