Results 101 to 110 of about 770,468 (299)
Wind tunnel model and method [PDF]
The design and development of a wind tunnel model equipped with pressure measuring devices are discussed. The pressure measuring orifices are integrally constructed in the wind tunnel model and do not contribute to distortions of the aerodynamic surface.
Jackson, C. M., Jr., Summerfield, D. G.
core +1 more source
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa +19 more
wiley +1 more source
Review on water disaster prevention of tunnels
Water disaster in tunnel engineering is a persistent problem in tunnel field. To address this issue, this paper summarizes the literature of water disaster prevention in tunnel engineering, defines the problem of water disaster in tunnel engineering ...
WANG Fuming +4 more
doaj +1 more source
Experimental Investigation on the Influence of Regional Concrete Spalling on Shield Tunnel Segments
Based on the field investigation and analysis, the mechanical characteristics of segment structure in shield tunnels are compared and analyzed under the circumstances of different concrete spalling region by the method of similarity model experiment ...
Shimin Wang +6 more
doaj +1 more source
Tunneling spectroscopy of superconducting MoN and NbTiN grown by atomic layer deposition
A tunneling spectroscopy study is presented of superconducting MoN and Nb$_{0.8}$Ti$_{0.2}$N thin films grown by atomic layer deposition (ALD). The films exhibited a superconducting gap of 2meV and 2.4meV respectively with a corresponding critical ...
Altin, Serdar +8 more
core +1 more source
Applying a high electric field to a doped organic semiconductor heats up the charge carrier distribution beyond the lattice temperature, enhancing conductivity. It is shown that the associated effective temperature can be used to extract the effective localization length, which is a characteristic length scale of charge transport and provides ...
Morteza Shokrani +4 more
wiley +1 more source
The long span deck type concrete filled steel tube (CFST) arch bridge encounters considerable safety risks under intricate traffic loads because to its extensive span, elevated columns, and pronounced dynamic sensitivity.This study utilizes the Wujiang ...
Yong Zeng +4 more
doaj +1 more source
Reducing power consumption in spintronic memory remains a major challenge due to the need for high current densities. A bilayer of gadolinium and holmium iron garnets enables purely temperature‐induced, nonvolatile magnetic switching with bistable states within a ±25 K range. This approach achieves up to 66‐fold lower energy use than current spin–orbit
Junseok Kim +3 more
wiley +1 more source
Subway tunnels, with their complex underground environment, frequently develop surface defects like cracks and water leakage over time. Traditional manual inspection methods are inadequate for current accuracy and efficiency needs.
Zunchao Ren +4 more
doaj +1 more source
Minimum Energy Test Direction Design in the Control of Cryogenic Wind Tunnels [PDF]
The advent of the cryogenic wind tunnel concept is attributable to the need for high Reynolds number flow in wind tunnels. The cryogenic wind tunnel concept consists of operating the test medium of a conventional tunnel at cryogenic temperatures down to ...
Balakrishna, S., Goglia, G. L.
core +1 more source

