Results 141 to 150 of about 682,757 (228)

Cooling Holes in Polymer Spur Gears: A Critical Analysis of Heat Dissipation Benefits and Mesh Stiffness Penalties

Journal of Applied Polymer Science, Volume 143, Issue 38, October 10, 2026.
Cooling holes provide a simple passive cooling strategy for polymer spur gears, reducing maximum operating temperature by up to 9.39% while introducing a measurable gear mesh stiffness penalty. A validated response‐surface model reveals how hole size and location govern this thermal–mechanical trade‐off, enabling design optimization for thermally and ...
Abderrahim Baccar, Ahmed Samet, Ahmed Hammami, Nuno Dourado, Ali Akrout, Mohamed Haddar   +5 more
wiley   +1 more source

Robust Thermochromic Photothermal Coating with Ultraslippery Anti-icing/Deicing and All-Season Temperature Regulation Performance. [PDF]

Research (Wash D C)
Sun S, Liu X, Wang Z, Yang C, Chen J, Zhao Z, Liu J, Zhang L, Chen H.   +8 more
europepmc   +1 more source

Nonwoven rCF/PA6 Thermoplastic Composites: Hybrid Commingled Fibers vs. Powder Impregnation—Effects on Microstructure and Mechanical Properties

Polymer Composites, Volume 47, Issue 19, Page 17076-17090, 10 October 2026.
Comparison of powder impregnation and hybrid commingled non‐wovens for PA6/rCF nonwoven composites. The two‐step powder route gives lower voids and higher properties, while the single‐step hybrid route is limited by precursor inhomogeneity and high void content.
Gaia Francesca Lupia, Tommaso Pini, Ilaria Rossitti, Sara Taherinezhad Tayebi, Marco Valente   +4 more
wiley   +1 more source

From Qualitative Localisation to Quantitative Verification: Integrating Active IR Thermography and Laser Scanning in Wind Turbine Blade Inspection. [PDF]

Materials (Basel)
Stawiarski A.
europepmc   +1 more source

Research Progress on Solar Energy Storage and Conversion Technologies for Sustainable Development: Prospects, Challenges, and Future Outlooks

Advanced Energy and Sustainability Research, Volume 7, Issue 10, October 2026.
This review focuses on the potential of solar energy and major solar energy storage technologies and provides a comparative assessment of their thermodynamic performance, storage density, efficiency, operating conditions, technological maturity, and application suitability.
Md. Golam Kibria, S. R. Shajid, Md. Shahriar Mohtasim, Md. Sanowar Hossain, Barun K. Das, Md Shamim Ahamed, Monjur Mourshed   +6 more
wiley   +1 more source

Comprehensive 4E (energy, exergy, economic, and environmental) assessment of a repowered natural gas-fired combined power plant. [PDF]

Sci Rep
Boukelia TE, Bouhala A, Cheurfi Y, Bessaïh R, Tanougast A, Hriczó K.   +5 more
europepmc   +1 more source

Combined Surface‐Bottom Aeration: A Pathway to Improved Water Quality and Productivity in Pond‐Based Tilapia Farming

Aquaculture, Fish and Fisheries, Volume 6, Issue 5, October 2026.
ABSTRACT Pond‐based aquaculture demands effective management of dissolved oxygen (DO) for sustainable intensification to improve productivity. This study evaluated surface aeration (SA), bottom aeration (BA) and combined surface‐bottom aeration (SBA) against a non‐aerated control during a 120‐day monoculture of Nile tilapia (Oreochromis niloticus ...
Mithun Roy, Md. Asaduzzaman, Debasish Saha, Md Rakeb‐Ul Islam, David C. Little, Richard Newton, Abu Tweb Abu Ahmed, Faruk‐Ul Islam, Md. Asadujjaman, Muhammad Tanvir Hossain Chowdhury, Abdullah‐Al Mamun   +10 more
wiley   +1 more source

Multiobjective Optimization Analysis of Gas-Steam Combined Cycle Coupled with Photovoltaic-Driven Hydrogen Electrolyzer System. [PDF]

ACS Omega
Chai L, Liu X, Song F, Huo Z, Wang W, Han Y.   +5 more
europepmc   +1 more source

Laser Surface Treatment of Nickel‐Alumina Coating for Enhancement of Erosion and Corrosion Resistance of High Speed Steel Vanes

Applied Research, Volume 5, Issue 5, October 2026.
Laser surface treatment was carried out to enhance the performance of Ni‐Al2O3 coatings on HSS substrates. The results revealed improved microstructural features, corrosion resistance and significant reduction in slurry erosion wear with 18 W laser treatment. ABSTRACT The sliding wear between hydraulic vane tip and the inner surface of the cam ring can
Majunath Keshav, Achutarao Bharatish, Sivakumar Solaiachari, Srilatha Rao   +3 more
wiley   +1 more source

Design and optimization scheme of sinter vertical cooler waste heat power generation plant based on EBSILON. [PDF]

Sci Rep
Li S, Wang W, Chikova OA, Xu W, Lyu Y.
europepmc   +1 more source