Results 21 to 30 of about 4,607 (209)
TWR Bench-Scale Steam Reforming Demonstration [PDF]
The Idaho Nuclear Technology and Engineering Center (INTEC) was home to nuclear fuel reprocessing activities for decades at the Idaho National Engineering and Environmental Laboratory. As a result of the reprocessing activities, INTEC has accumulated approximately one million gallons of acidic, radioactive, sodium-bearing waste (SBW).
Marshall, D. W., Soelberg, N. R.
openaire +6 more sources
Effect of changing polarity of graphite tool/ Hadfield steel workpiece couple on machining performances in die sinking EDM [PDF]
In this study, machining performance ouput parameters such as machined surface roughness (SR), material removal rate (MRR), tool wear rate (TWR), were experimentally examined and analyzed with the diversifying and changing machining parameters in (EDM ...
Özerkan Haci Bekir
doaj +2 more sources
Multi-response optimization of PMEDM on Inconel 718 using hybrid T-GRA, TOPSIS, and ANN model [PDF]
Inconel 718 is one of the Nickel-based superalloys considered one of the most difficult-to-machine materials owing to its property to retain hardness at higher temperatures.
Sai Ram Jana +2 more
doaj +1 more source
Mine personnel position monitoring technology
This paper analyzes the technologies of mine ranging and positioning, such as ultrasound, laser, video, inertial navigation, pedometer, and radio.
SUN Jiping
doaj +1 more source
Gear failure caused by traveling wave resonance (TWR) generally occurs quite suddenly and causes catastrophic results in aero-engines. In this study, the TWR characteristics and stress distribution characteristics of a high-speed bevel gear in an aero ...
Xiaochi Luan +4 more
doaj +1 more source
Effect of SiC-Cu Electrode on Material Removal Rate, Tool Wear and Surface Roughness in EDM Process [PDF]
Electrical discharge machining (EDM) is one of the most common non-traditional processes for the manufacture of high precision parts and complex shapes. The EDM process depends on the heat energy between the work material and the tool electrode.
Yousif Laibi, Saad Shather
doaj +1 more source
Influence of graphene coating in electrical discharge machining with an aluminum electrode
Since the cost of electrodes in electrical discharge machining (EDM) is usually too high, it leads to a significant increase in the production cost.
Pham Van Dong +6 more
doaj +1 more source
TOF underground accurate positioning technology based on message multiplexing
In view of problems that symmetric-double-sided two-way ranging (SDS-TWR) method had low ranging efficiency and poor expansibility and there was still room for improvement in the ranging efficiency and positioning system capacity of asymmetric-double ...
CHEN Kang +5 more
doaj +1 more source
TWR-MCAE: A Data Augmentation Method for Through-the-Wall Radar Human Motion Recognition
To solve the problems of reduced accuracy and prolonging convergence time of through-the-wall radar (TWR) human motion due to wall attenuation, multipath effect, and system interference, we propose a multilink auto-encoding neural network (TWR-MCAE) data
Yang, Xiaopeng +3 more
core +1 more source
UWB-TWR performance comparison in a hybrid node network
This thesis investigated the performance of a positioning system that utilised UWB technology where devices regularly shifts between acting as an initiator and as a responder for distance measurements between each other.
Sundin, Oskar
core +1 more source

