Results 41 to 50 of about 2,766 (276)

Investigation of electrostatic-assisted ultrasonic atomization and spraying

The International Journal of Advanced Manufacturing Technology, 2023
Abstract Ultrasonic atomization technology has been widely used in industry in recent years due to its higher atomization efficiency. This paper proposes a method of electrostatic-assisted ultrasonic atomization spraying and designs a special ultrasonic power supply that can directly introduce high-voltage static electricity onto the surface of
Yue Yang, Songmei Yuan, Zikang Zhang, Tie Lu   +3 more
openaire   +1 more source

Influence of Process Parameters on the Ultrasonic Atomization Efficiency and Possibility of Testing Properties of Liquid Metals

Metrology
Over recent years, ultrasonic atomization, especially with regard to liquid metals, has become an object of increased interest, mainly from industry, for additive manufacturing, but also from investigators, for research purposes.
Rafał Szostak-Staropiętka, Wojciech Presz, Roksana Pawlic, Anna Dziubińska, Katarzyna Kołacz   +4 more
doaj   +1 more source

THE POTENTIALS OF ULTRASONIC ATOMIZER AUGMENTED THE SEA SALT PRODUCTIONS

Logic
Ultrasonic atomizers can potentially augment the production of sea salt through a process known as ultrasonic nebulization. While the traditional method of sea salt production primarily relies on natural evaporation, ultrasonic atomization can accelerate
I Dewa Gede Agus Tri Putra, Putu Wijaya Sunu, Nyoman Sugiartha, I Nyoman Gede Baliarta, I Wayan Temaja   +4 more
doaj   +1 more source

Screening and epitope characterization of Nidogen‐2‐specific nanobodies

FEBS Open Bio, EarlyView.
Camel immunization and phage display were employed to generate high‐affinity VHH nanobodies against Nidogen‐2. After library construction, biopanning, ELISA screening, sequencing, and recombinant expression, selected nanobodies were purified and characterized, leading to the preliminary exploration of a nanobody‐based sandwich ELISA for specific ...
Jianchuan Wen, Qianqian Cui, Zhongyun Lan, Yingjun Wang, Shuaiying Zhao, Wenxuan Feng, Yunfeng Liu, Qiting Huang, Dongna Zhang, Jianfeng Xu   +9 more
wiley   +1 more source

Early‐life high‐fat diet exposure increases Achilles tendon stiffness and induces transcriptomic alterations

FEBS Open Bio, EarlyView.
Early‐life exposure to a high‐fat diet altered intact Achilles tendons in rat offspring, making them thinner, stiffer, and molecularly distinct even without injury. These findings suggest that developmental high‐fat diet exposure may impair tendon quality and increase susceptibility to mechanical overload or tendon injury later in life.
Heyong Yin, Ziyang Yuan, Wenli Jiang, Ai Guo   +3 more
wiley   +1 more source

Design and simulation of the new ultrasonic atomizer using silicon-based with one step resonator

Results in Physics, 2020
The design and simulation of a new generation Fourier amplifier were investigated in this study. The design and characterization of 500 kHz micro fabricated silicon-based ultrasonic atomization is presented for the concept of uniform and fine droplets ...
Yu-Lin Song, Lavanya Bandi
doaj   +1 more source

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

Advanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin, Samson Dare Oguntuyi, Peter Apata Olubambi   +2 more
wiley   +1 more source

Microstructural Evolution and Vacancy Defect Formation in Mn–Mo–Ni RPV Steel Under Low Cycle Fatigue: Insights From EBSD and PALS

Advanced Engineering Materials, EarlyView.
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar, Dhanadeep Dutta, G. Bharat Reddy   +2 more
wiley   +1 more source

Analysis of size correlations for microdroplets produced by ultrasonic atomization [PDF]

, 2020
Microencapsulation techniques are widely applied in the field of pharmaceutical production to control drugs release in time and in physiological environments.
Anna Angela Barba, Matteo D'amore, Annalisa Dalmoro   +2 more
core  

New insights into the mechanism of ultrasonic atomization for the production of metal powders in additive manufacturing [PDF]

Ultrasonic atomization is one of the promising technologies for producing metal powders for additive manufacturing, where precise control of particle size and morphology is essential. In this study, we coupled an ultrasonic transducer with a carbon fiber
Zrodowski, Lukasz, Bin Shahrani, Shazamin, Lee, Peter D., Eskin, Dmitry, Mi, Jiawei, Priyadarshi, Abhinav, Fezzaa, Kamel, Leung, Chu Lun Alex, Choma, Tomasz, Qin, Ling, Clark, Samuel J., Tzanakis, Iakovos   +11 more
core   +7 more sources