Results 1 to 10 of about 203 (115)
Impact of Wedge Parameters on Ultrasonic Lamb Wave Liquid-Level Sensor
The ultrasonic Lamb wave detection principle can realize the noncontact measurement of liquid level in closed containers. When designing an ultrasonic Lamb wave sensor, it is vital to thoroughly study and select the optimal wedge size at the front of the
Weizhao Xue +4 more
doaj +3 more sources
Clusters of Shaped Ultrasonic Transducers for Lamb Waves’ DoA Estimation [PDF]
The direction of arrival (DoA) estimation of Lamb waves is a fundamental task to locate acoustic events, such as those caused by impacts in plates or shells. To perform this task, a novel cluster of piezoelectric sensors is presented in this work.
Marco Dibiase, Luca De Marchi
doaj +3 more sources
Application of Air-Coupled Ultrasonic Arrays for Excitation of a Slow Antisymmetric Lamb Wave
Air-coupled excitation and reception of ultrasonic guided waves is already used for non-destructive testing and evaluation (NDT & E). Usually for air-coupled NDT & E purposes the lowest zero-order antisymmetric Lamb wave mode A0 is used, because ...
Rymantas J. Kazys +2 more
doaj +3 more sources
Application of non-contact ultrasonic method in air to study fiber-cement corrugated boards [PDF]
The fiber-cement and cellulose boards are materials commonly used in architectural engineering for exterior and interior applications such as building facades or as wall and roof covering materials.
Radosław Drelich +2 more
doaj +1 more source
SETTING OF THE ANGLE OF INCIDENCE FOR GENERATING LAMB WAVES BY NON-CONTACT METHOD [PDF]
The article examined the problem of the experimental setting of incidence angles for the generation of Lamb waves in plate-type parts by the non-contact ultrasonic control method.
BUGA, Alexandru
doaj +1 more source
This article proposes an electromagnetic acoustic transducer (EMAT) for selectively improving the purity and amplitude of ultrasonic Lamb waves in non-ferromagnetic plates. The developed EMAT consists of a racetrack coil and a group of periodic permanent
Xinfeng Guo +3 more
doaj +1 more source
The Suitability of Using 3D PLA Printed Wedges for Ultrasonic Wave Propagation
This work studies the suitability of using 3D printed PLA wedges made through additive manufacturing to propagate Lamb waves in plate structures instead of using rather more expensive commercial wedges.
Antonio J. Balvantin +5 more
doaj +1 more source
Numerical Investigation of Excitation of Various Lamb Waves Modes in Thin Plastic Films
Ultrasonic-guided waves are widely used for the non-destructive testing and material characterization of plates and thin films. In the case of thin plastic polyvinyl chloride (PVC), films up to 3.2 MHz with only two Lamb wave modes, antisymmetrical A0 ...
Rymantas Jonas Kazys +2 more
doaj +1 more source
Numerical Simulation of Nonlinear Lamb Waves Used in a Thin Plate for Detecting Buried Micro-Cracks
Compared with conventional linear ultrasonic inspection methods, which are sensitive only to severe defects, nonlinear ultrasonic inspection methods are better for revealing micro-cracks in thin plates.
Xiang Wan +3 more
doaj +1 more source
Ultrasonic testing is an important means to detect defacing defects, such as scratches and cracks, but when the size of these defects is smaller than the wavelength of ultrasonic waves, it is difficult to detect them using traditional methods like the ...
Peng Zhou, Chu Zhang, Ke Xu, Weiping Ren
doaj +1 more source

