Results 11 to 20 of about 2,848 (264)
INVESTIGATION INTO THE PRODUCTION FLAWS IN THIN SOLID CARBON LAMINATES BY USING THE ULTRASONIC PHASED ARRAY METHOD [PDF]
Scientific Journal of Silesian University of Technology. Series Transport, 2018 Composites are used in a wide variety of markets, including the aerospace, architecture, automotive and military sectors. Along with the increased use of composites, multiple non-destructive testing (NDT) methods have been further developed specifically ...
Jan PIL’A +2 more
doaj +1 more source
Numerical Investigation of Excitation of Various Lamb Waves Modes in Thin Plastic Films
Applied Sciences, 2022 Ultrasonic-guided waves are widely used for the non-destructive testing and material characterization of plates and thin films. In the case of thin plastic polyvinyl chloride (PVC), films up to 3.2 MHz with only two Lamb wave modes, antisymmetrical A0 ...
Rymantas Jonas Kazys +2 more
doaj +1 more source
Haptic Interface Device Using Cable Tension Based on Ultrasonic Phased Array
IEEE Access, 2020 This paper presents a new haptics interface device based on cable-driven parallel manipulators and an ultrasonic phased array. Unlike previous studies, our method combines force and tactile feedback at the same time.
Liqiang Fan, Aiguo Song, Haochen Zhang
doaj +1 more source
Research on factors affecting ultrasonic phased array detection imaging quality for curved component
AIP Advances, 2022 An in-depth analysis on the beam directivity of ultrasonic phased arrays has been made to solve the problems of low image quality and identification difficulties caused by a suboptimal configuration of array elements.
Zhe Wang, Chao Zhang, Xiahui Li
doaj +1 more source
Cailiao gongcheng, 2021 Composite materials are prone to delamination defects during the preparation process. For the non-destructive testing and evaluation of carbon fiber reinforced polymer (CFRP) delamination defects, a standard specimen with embedded delamination defects ...
CAO Hong-yi +8 more
doaj +1 more source
International Journal of Distributed Sensor Networks, 2013 Near-field ultrasonic phased array theory is researched and utilized in the carbon-fiber wing box to identify the damage in the structure. Near-field ultrasonic phased array based structural health monitoring is researched to overcome the limitation of ...
Yajie Sun +3 more
doaj +1 more source
An Omnidirectional Near-Field Comprehensive Damage Detection Method for Composite Structures
Applied Sciences, 2019 As one of the active structural health monitoring methods based on the Lamb wave, the ultrasonic phased-array damage detection method can provide information such as damage location and range more intuitively, which is why this method is a research ...
Zhiling Wang +3 more
doaj +1 more source
Applied Sciences, 2021 The use of pulse-compression in ultrasonic non-destructive testing has assured, in various applications, a significant improvement in the signal-to-noise ratio.
Muhammad Khalid Rizwan +4 more
doaj +1 more source
Strategies for data acquisition using ultrasonic phased arrays [PDF]
Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2018 Ultrasonic phased arrays have produced major benefits in a range of fields, from medical imaging to non-destructive evaluation. The maximum information, which can be measured by an array, corresponds to the Full Matrix Capture (FMC) data acquisition technique and contains all possible combinations of transmitter–receiver signals.
A. Velichko, A. J. Croxford
openaire +4 more sources
Optimization Design of Phased Array Ultrasonic Transducer Arrays
DEStech Transactions on Computer Science and Engineering, 2018 The design and selection of the transducer array parameters directly affect the performance of the audio directional transmission system. In this paper, the influence of the number of array element, the pitch, the frequency and the deflection angle on the array directivity is analyzed in detail.
Zhi-qian KANG, Xi-hai LI, Xiang-yu LI
openaire +2 more sources