Results 21 to 30 of about 1,134,620 (95)

Fatigue Life Degradation Model for Anchor-Induced Indentation Damage in the Touchdown Zone of Unbonded Flexible Risers

open access: yesApplied Sciences
Waves, currents, and platform motions subject the touchdown zone (TDZ) of unbonded flexible risers to sustained cyclic loading, making it highly susceptible to fatigue failure. Local indentation damage caused by dropped anchors alters the stress state of
Xianjing Bai   +5 more
doaj   +1 more source

A Parametric Computational Framework for Modeling and Seismic Design of Post‐Tensioned Mass Timber Rocking Walls

open access: yesEarthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Post‐tensioned cross‐laminated timber (PT‐CLT) rocking walls offer a compelling seismic system combining self‐centering behavior with energy dissipation. However, progress in their performance assessment and design has been limited by the lack of a comprehensive parametric modeling tool, as exists for steel or reinforced concrete systems. This
Ghasem B. Shargh   +3 more
wiley   +1 more source

Experimental Study on the Lateral Response of Large‐Scale Unbonded Steel‐Mesh‐Reinforced Rubber Bearings

open access: yesEarthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Conventional unbonded elastomeric bearings (ULNRs) are cost‐effective but prone to sliding during earthquakes due to their limited shear deformability. Unbonded Steel‐Mesh‐Reinforced Rubber Bearings (USRBs) offer a solution with increased deformation capacity.
Han Li, Jie Shen, M. Shahria Alam
wiley   +1 more source

Numerical Simulations of 5‐Story Building Using Wood Light‐Frame Shear Walls and Post‐Tensioned Cross‐Laminated Timber Rocking Wall Dual Systems

open access: yesEarthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT This study explores the seismic performance of a five‐story prototype building using different configurations of a dual lateral force‐resisting system (LFRS) combining post‐tensioned cross‐laminated timber rocking walls (PT‐CLT‐RW) with conventional wood light‐frame shear walls (LiFS).
Ruben Jerves, Adam R. Phillips
wiley   +1 more source

Reinforcement of Polyvinyl Chloride Using Plasma‐Activated Aramid Fibers and Surface‐Bonded Compatibilizer

open access: yesPolymer Composites, EarlyView.
Two‐step compatibiization of aramid fibers with PVC via Plasma Activation and surface reaction. ABSTRACT This study investigated the application of a two‐step compatibilization procedure to aramid fiber–polyvinyl chloride (PVC) composites. Aramid fibers were subjected to high radio frequency power air plasma treatment and incorporated into the PVC ...
Adekunle Lawrence Omoniyi   +3 more
wiley   +1 more source

Integrating Grain to Ground Motion Data for Critical Rock Bridge and Slope Failure Analysis

open access: yesInternational Journal for Numerical and Analytical Methods in Geomechanics, Volume 50, Issue 16, Page 5891-5918, November 2026.
ABSTRACT Rock masses can fail catastrophically with little warning, yet their stability depends on hidden internal connections that channel forces and localise damage. Among these, rock bridges–a “known unknown” in slope mechanics–lock fractured rock and control how failure unfolds, but their concealed geometry and uncertain strength obscure where and ...
Antoinette Tordesillas   +5 more
wiley   +1 more source

Thermoplastic Dielectric Coatings for Flexible Electrodynamic Dust Shields: Structural and Functional Performance

open access: yesAdvanced Materials Interfaces, Volume 13, Issue 20, 21 October 2026.
Thermoplastic attachment is introduced as a scalable surface coating strategy to improve the durability and dielectric reliability of flexible electrodynamic dust shields. By embedding chemically modified reduced graphene oxide (CMrGO) electrodes within thermoplastic laminates, mechanical degradation, abrasion damage, and vacuum‐induced electrical ...
Ide E. Onal   +6 more
wiley   +1 more source

Raman Evidence of Moiré Diamondene Formation by High‐Pressure

open access: yesAdvanced Science, Volume 13, Issue 54, 28 September 2026.
Two‐dimensional moiré diamondene is formed at approximately 2 GPa through the synergy of high pressure, interlayer twist, and a chemically active diamond (100) surface. It is a hybrid sp2–sp3 nanostructure, consists of localized nanodiamond domains and unbonded graphene segments.
Chaofeng Gao   +13 more
wiley   +1 more source

Discovering Shared Design Heritage for Semiconductor‐Based Gamma‐Ray Spectrometers: From CdTe to Metal Halide Perovskites

open access: yesLaser &Photonics Reviews, Volume 20, Issue 17, 3 September 2026.
Decades of CdTe and CdZnTe gamma‐ray spectrometer development define core design principles for room‐temperature semiconductor detectors. This Review highlights how metal halide perovskites rapidly assimilate these principles, particularly through defect and compositional engineering strategies that establish favorable spectroscopic conditions for ...
Younghak Kim   +7 more
wiley   +1 more source

Polarity‐Engineered, Tribo‐Positive Imidazolium‐Mediated Crosslinked 6FDA‐Durene Films for Triboelectric Nanogenerator

open access: yesSmall, Volume 22, Issue 50, 7 September 2026.
Imidazolium‐mediated crosslinking transforms 6FDA‐durene PI from tribo‐negative to tribo‐positive by modulating the surface electronic structure and charge‐transfer behavior. DFT calculations confirm the experimentally observed polarity transition.
Sorour Faramarzi   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy