Cutting Forces Simulation for End Milling
Журнал інженерних наук, 2023 The cutting force in end milling is the essential perturbation of the machining system that limits the productivity of the process. Therefore, forecasting the cutting force when assigning the processing mode and the geometry of the allowance layer to be ...
Petrakov Y. V. +3 more
doaj +1 more source
Geophysical Monograph Series, Page 97-104., 2020 This book is Open Access. A digital copy can be downloaded for free from Wiley Online Library.
Explores the behavior of carbon in minerals, melts, and fluids under extreme conditions
Carbon trapped in diamonds and carbonate-bearing rocks in subduction zones are examples of the continuing exchange of substantial carbon ...
Daniele Cherniak +2 more
wiley +1 more source
Crystals, 2023 The grinding force is an important index during the grinding process, which affects the surface quality and other aspects after machining. However, the research on the grinding force of ceramic matrix composites assisted by two-dimensional ultrasonic ...
Yunguang Zhou +5 more
doaj +1 more source
Prediction of Grinding Force by an Electroplated Grinding Wheel with Orderly-Micro-Grooves
Chinese Journal of Mechanical Engineering, 2023 The ability to predict a grinding force is important to control, monitor, and optimize the grinding process. Few theoretical models were developed to predict grinding forces when a structured wheel was used in a grinding process.
Cong Mao +9 more
doaj +1 more source
Metals, 2022 The peripheral surface of the grinding wheel can grind the rail according to the envelope of the contour of the rail surface, thus a fuller and smoother rail surface can be obtained.
Changhao Chen +5 more
doaj +1 more source
Determination of micro-scale plastic strain caused by orthogonal cutting [PDF]
, 2008 An electron beam lithography technique has been used to produce microgrids in order to measure local plastic strains, induced during an orthogonal cutting process, at the microscopic scale in the shear zone and under the machined surface. Microgrids with
Allais +31 more
core +1 more source
Scaling properties of a low-actuation pressure microfluidic valve [PDF]
, 2004 Using basic physical arguments, we present a design and method for the fabrication of microfluidic valves using multilayer soft lithography. These on-off valves have extremely low actuation pressures and can be used to fabricate active functions, such as
Anna Pandolfi +10 more
core +1 more source
Simulation of a finishing operation : milling of a turbine blade and influence of damping [PDF]
, 2012 Milling is used to create very complex geometries and thin parts, such as turbine blades. Irreversible geometric defects may appear during finishing operations when a high surface quality is expected.
BALMES, Etienne +4 more
core +5 more sources
Metals, 2023 Analytical cutting models have recently become quite widespread due to the simplicity and rapidity of calculations as well as the stability of the solutions.
Michael Storchak, Maria A. Lekveishvili
doaj +1 more source
An investigation on the mechanics of nanometric cutting and the development of its test-bed [PDF]
, 2003 The mechanics of machining at a very small depth of cut (100 nm or less) is not well understood. The chip formation physics, cutting forces generation, resulting temperatures and the size effects significantly affect the efficiency of the process and ...
Cheng, K, Guo, XJ, Holt, R, Luo, X
core +2 more sources