Results 81 to 90 of about 46,783 (309)

Self‐Powered Bearing Sensing and Real‐Time Fault Diagnosis Enabled by Non‐Invasive Triboelectric Sensors and Edge AI Acceleration

open access: yesAdvanced Science, EarlyView.
This study achieves the synergistic integration of self‐powered sensing and edge AI acceleration to establish a real‐time fault diagnosis system. The proposed TENG‐based self‐powered bearing sensor (NSE‐TBS) and FPGA‐accelerated edge AI framework fundamentally break through the inherent limitations of conventional monitoring systems, including complex ...
Kehui Zhu   +7 more
wiley   +1 more source

Characterization of Tribofilm with the Remaining Lubricating Oil by Raman Spectroscopy

open access: yesTribology Online, 2015
As a first step to develop a method of in situ analysis of tribological behavior under oil lubrication, surfaces after the tribo-test with the remaining lubricating oil were analyzed with Raman spectroscopy.
Makoto Miyajima   +2 more
doaj   +1 more source

Evaluation of the lipase from castor bean (Ricinus Communis L.) as a potential agent for the remediation of used lubricating oil contaminated soils. [PDF]

open access: yesJ Environ Health Sci Eng, 2022
Aguilera Flores MM   +4 more
europepmc   +1 more source

Optimization of Heat Exchanger Design Parameters for Hydrocarbon Refrigerant Systems [PDF]

open access: yes, 2004
Hydrocarbon refrigerants (HC's) are one alternative to hydrofluorocarbons (HFC???s) since they have zero ozone depletion potential and negligible global warming potential.
Bullard, C.W., Jain, S.
core  

Concentric Rheostat Decoupled 3D Force‐Sensing Module for Smart Table Tennis Training

open access: yesAdvanced Intelligent Systems, EarlyView.
A 3D‐printed sensor array intrinsically decouples normal and shear forces through a unique concentric structural design. By integrating piezoresistive, sliding area‐varying capacitive, and concentric rheostat mechanisms, the 12‐sensor module achieves high‐resolution 3D force mapping without complex algorithms.
Zhe Liu   +7 more
wiley   +1 more source

SATUFER Method for Determining the Degree of Lubricating Oil Dilution with Diesel Oil in an Internal Combustion Engine Lubrication System

open access: yesEnergies
This article presents a proposed a new method for estimating the degree of dilution of lubricating oil with diesel oil, which can be applied to systems for ongoing monitoring of lubricating oil quality in an internal combustion engine.
Leszek Chybowski   +2 more
doaj   +1 more source

Monitoring of lubricant film failure in a ball bearing using ultrasound [PDF]

open access: yes, 2006
A lubricant-film monitoring system for a conventional deep groove ball bearing (type 6016, shaft diameter 80 mm, ball diameter 12.7 mm) is described. A high-firequency (50 MHz) ultrasonic transducer is mounted on the static outer raceway of the bearing ...
Anderson   +21 more
core   +1 more source

Clotrimazole‐loaded PLGA microparticles for local drug delivery to the vagina: Shape does matter

open access: yesAnimal Models and Experimental Medicine, EarlyView.
Clotrimazole‐loaded PLGA microparticles for intravaginal delivery. Abstract Background Intravaginal drug administration is the most promising strategy for treating vaginal infections to protect women's health, such as vulvovaginal candidiasis (VVC). However, conventional vaginal formulations in the clinic face challenges such as drug leakage and low ...
Yanyu Li   +8 more
wiley   +1 more source

Assessment of Used Motor Oil Recycling Opportunities in the United Arab Emirates

open access: yesJournal of King Saud University: Engineering Sciences, 2004
The treating and refining of used motor oil in United Arab Emirates (UAE) to convert it to recyclable products are investigated. Opportunities to convert the used motor oil to environmentally friendly products are explored. Laboratory analysis of various
Ahmad Hamad   +2 more
doaj   +1 more source

Tribological investigations of the piston assembly and liner of a gasoline engine [PDF]

open access: yes, 2008
The automotive industry is being forced towards greater efficiency, increased engine power from smaller engines and lower environmental impact by both governmental legislation and public opinion.
Lee, P.M.
core  

Home - About - Disclaimer - Privacy