Results 161 to 170 of about 1,041 (200)

Vacuum glazing for highly insulating windows: Recent developments and future prospects

Renewable and Sustainable Energy Reviews, 2016
A comprehensive review of vacuum glazing technology from state-of-the-art developments to future prospects has been presented. The review has been conducted in a thematic way in order to allow an easier comparison, discussion and evaluation of the ...
Erdem Cucé
exaly   +2 more sources

Effect of atmospheric transmittance on performance of adaptive SPD-vacuum switchable glazing

Solar Energy Materials and Solar Cells, 2017
Combined suspended particle device (SPD)-vacuum glazing is a potential adaptive glazing for low energy building application. Glazing transmission is an essential parameter to determine indoor comfort level of building due to glazing.
Aritra Ghosh, B Norton
exaly   +3 more sources

Analysis of the Performance of Vacuum Glazing in Office Buildings in Korea: Simulation and Experimental Studies

Sustainability, 2017
Window performance in buildings is very important for energy saving. Many efforts have been made towards saving energy in buildings, and research has focused attention on enhancing the thermal performance of windows.
Seok-Hyun Kim
exaly   +2 more sources

Some of the next articles are maybe not open access.

Related searches:

Thermal outgassing of vacuum glazing

Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films, 1999
Vacuum glazing consists of two sheets of glass separated by a narrow evacuated space. In this article we describe investigations of the causes of thermally induced degradation of vacuum glazing. It is shown that the rate of increase of pressure within the glazing during high temperature aging is mainly determined by the diffusion of water out of near ...
M. Lenzen, G. M. Turner, R. E. Collins
openaire   +1 more source

Getters for vacuum insulated glazing

Vacuum, 2018
Abstract The vacuum problem in sealed off chambers of VIGs type has been solved. The solution is based on two innovations. The first one is the usage of activationless getters in a form powders or granules of the composition Ca0.35Li0.45Mg0.20 instead of barium. The second one – the changed sequence of assembling the vacuum window at which the getter
K. Chuntonov, A.O. Ivanov, B. Verbitsky, J. Setina   +3 more
openaire   +1 more source

Manufacture and cost of vacuum glazing

Fuel and Energy Abstracts, 1995
The vacuum glazing project at the University of Sydney has progressed to the point where the main features of the vacuum glazing design are determined well. Over 500 glazings with areas up to one square meter have been formed. The stresses to which these glazings are or may be exposed have been studied extensively.
J.D. Garrison, R.E. Collins
openaire   +1 more source

Photodesorption of gases in vacuum glazing

Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films, 2003
When samples of vacuum glazing are exposed to sunlight, the pressure within these devices is observed to increase. The major gas species released have been identified using mass spectroscopic techniques, and are found to be carbon monoxide and carbon dioxide rather than water vapor as in thermally degraded vacuum glazing. Different measuring techniques,
N. Ng, R. E. Collins, L. So
openaire   +1 more source

Evacuation and outgassing of vacuum glazing

Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films, 2000
The evacuation and outgassing of vacuum glazing is studied by modeling and experimental methods. A two-dimensional finite difference method of modeling the pumpdown process is validated by comparison with a one dimensional, cylindrically symmetric finite difference method, and with measurements on experimental samples. In the absence of outgassing, the
N. Ng, R. E. Collins
openaire   +1 more source

Thermal conductance measurement on vacuum glazing

International Journal of Heat and Mass Transfer, 2006
zbMATH Open Web Interface contents unavailable due to conflicting licenses.
Ng, N., Collins, R. E., So, L.
openaire   +1 more source

Vacuum glazing units and solar collectors

Applied Solar Energy, 2008
Possible application of vacuum glazing (VG) units for transparent insulation of solar collectors (SC) to reduce their heat losses is considered. Taking into account the SC operating conditions, the heat insulating parameters of VG samples measuring 0.3 × 0.3 m2 and 0.5 × 0.5 m2 are experimentally studied and compared to those of double glazing (DG) of ...
S. N. Trushevskii, I. V. Mitina
openaire   +1 more source