Results 121 to 130 of about 1,324 (170)
Some of the next articles are maybe not open access.
Impulse current withstanding capability of ZnO varistors with influence of varistor size
IEEJ Transactions on Electrical and Electronic Engineering, 2019Through injecting 8/20 and 30/60 μs impulse currents to five kinds of ZnO varistors, the influence of the varistor size on the single impulse current withstanding capability of a ZnO varistor is investigated in this article. A comprehensive damage criterion of a varistor consisting of three aspects, namely, mechanical failure by visual inspection ...
Jianguo Wang +5 more
openaire +1 more source
Journal of Applied Physics, 1988
A composite varistor material containing silicon carbide, a conductor, and an insulator has been developed. The material has rubberlike flexibility and is easily formed. A higher leakage resistivity (∼1012 Ω cm) and greater nonlinearity (∼10) than for silicon carbide varistors permit the material to be used as a gapless surge suppressor.
F. A. Modine, H. M. Hyatt
openaire +1 more source
A composite varistor material containing silicon carbide, a conductor, and an insulator has been developed. The material has rubberlike flexibility and is easily formed. A higher leakage resistivity (∼1012 Ω cm) and greater nonlinearity (∼10) than for silicon carbide varistors permit the material to be used as a gapless surge suppressor.
F. A. Modine, H. M. Hyatt
openaire +1 more source
Journal of the American Ceramic Society, 1999
The development of varistor ceramics is reviewed with an emphasis on ZnO‐based varistors formed by liquid‐phase sintering. Particular attention is given to the effects of microstructural disorder on the properties of varistors and to the different modes of failure that can occur.
openaire +1 more source
The development of varistor ceramics is reviewed with an emphasis on ZnO‐based varistors formed by liquid‐phase sintering. Particular attention is given to the effects of microstructural disorder on the properties of varistors and to the different modes of failure that can occur.
openaire +1 more source
Microchemistry of ZnO Varistors
Proceedings, annual meeting, Electron Microscopy Society of America, 1992ZnO varistors are made by mixing semiconducting ZnO powder with powders of other metal oxides e.g. Bi2O3, Sb2O3, CoO, MnO2, NiO, Cr2O3, SiO2 etc., followed by conventional pressing and sintering. The non-linear I-V characteristics of ZnO varistors result from the unique properties that the grain boundaries acquire as a result of dopant distribution ...
K. K. Soni +4 more
openaire +1 more source
[1991 Proceedings] 6th Mediterranean Electrotechnical Conference, 2002
Two shapes of interdigitated planar varistors were made using thick-film technology on alumina substrates. These varistor were based on ZnO paste. The distance between varistor electrodes were changed from 0.2 to 1.91 mm, and the total length of the electrodes from 49 to 230 mm.
T.D. Grozdic +3 more
openaire +1 more source
Two shapes of interdigitated planar varistors were made using thick-film technology on alumina substrates. These varistor were based on ZnO paste. The distance between varistor electrodes were changed from 0.2 to 1.91 mm, and the total length of the electrodes from 49 to 230 mm.
T.D. Grozdic +3 more
openaire +1 more source
Sintering effect on varistor properties and degradation behavior of ZVMB varistor ceramics
Journal of Materials Science: Materials in Electronics, 2017ZnO–V2O5–Mn3O4–Bi2O3 (ZVMB) varistor ceramics were sintered at a low temperature range of 800–875 °C, and the microstructure, electrical properties, dielectric characteristics, and DC-accelerated aging behavior were systematically investigated. Analysis of the microstructure indicated that the average grain size increased from 3.8 to 6.4 µm with the ...
openaire +1 more source
[1991] Proceedings of the 3rd International Conference on Properties and Applications of Dielectric Materials, 2002
The frequency characteristics of the capacity and the dissipation factor of a ceramic ring varistor have been measured in the range from 10 kHz to 1 MHz. From the measurements, the equivalent circuit was determined, considering the internal structure of the ceramic ring varistor.
M. Suzuki +3 more
openaire +1 more source
The frequency characteristics of the capacity and the dissipation factor of a ceramic ring varistor have been measured in the range from 10 kHz to 1 MHz. From the measurements, the equivalent circuit was determined, considering the internal structure of the ceramic ring varistor.
M. Suzuki +3 more
openaire +1 more source
Journal of Physics: Condensed Matter, 1993
Among the mechanisms suggested to account for degradation of varistor materials, ion migration has strong support. Mobile, positively charged ions in the depletion layer would be the key element in degradation. In this context, the authors discuss the consequences of an electrical stressing on the current-temperature characteristic of a comment ...
M S Castro, M A Benavente, C M Aldao
openaire +1 more source
Among the mechanisms suggested to account for degradation of varistor materials, ion migration has strong support. Mobile, positively charged ions in the depletion layer would be the key element in degradation. In this context, the authors discuss the consequences of an electrical stressing on the current-temperature characteristic of a comment ...
M S Castro, M A Benavente, C M Aldao
openaire +1 more source
MRS Proceedings, 1981
The theory of ZnO varistors has evolved along with the increasingly detailed experimental description [1-2]. The extreme nonlinearity in the currentvoltage curves naturally led the early investigators to suggest the well-known nonlinear mechanisms, such as space-charge limited currents or electron tunneling. Later experiments made these first proposals
openaire +1 more source
The theory of ZnO varistors has evolved along with the increasingly detailed experimental description [1-2]. The extreme nonlinearity in the currentvoltage curves naturally led the early investigators to suggest the well-known nonlinear mechanisms, such as space-charge limited currents or electron tunneling. Later experiments made these first proposals
openaire +1 more source
Polarization currents in varistors
Journal of Applied Physics, 1990The time, voltage, and temperature dependencies of transient polarization currents are reported for two types of varistors (i.e., ZnO and a SiC composite). The current transients exhibit a power-law time response to a step change in voltage (i.e., I≊I0/tm, where m is slightly less than unity) that persists over a time scale exceeding 10−8–104 s.
F. A. Modine +4 more
openaire +1 more source