Results 61 to 70 of about 1,546 (174)

Synthesis and current-voltage characterization of tin dioxide varistors

, 1999
An overview of the steady state electrical properties of tin dioxide varistors is presented. The varistors are manufactured in two ways: (1) a ceramic route by mixing and compaction of tin dioxide powder with various dopants and (2) a sol-gel method ...
A. S. Kale, S. K. Date, R. N. Barve, Santhosh, P. N., Date, S. K., P. N. Santhosh, Kale, A. S., S. Seal, Barve, R. N., Seal, S.   +9 more
core   +2 more sources

The Influence of Ni2O3 Doping Concentration on the Alternating Current Aging Characteristics of ZnO Varistor

International Journal of Ceramic Engineering &Science, Volume 8, Issue 1, January 2026.
ABSTRACT When the surge arrester is subjected to the working voltage for an extended period, it undergoes alternating current (AC) aging, which degrades the arrester's parameters and affects the safety of the power grid. Ni2O3 is an important additive in the ZnO varistor formulation, and its doping ratio significantly influences the performance of the ...
Lei Wang, Jian Zhang, Wenbo Yu, Lu Li, Xin Cheng   +4 more
wiley   +1 more source

Processing of textured zinc oxide varistors via templated grain growth

, 2005
WOS: 000230039800024Textured, dense zinc oxide varistors were successfully fabricated by Templated Grain Growth (TGG) technique. Rod-like, anisotropic ZnO particles (templates) were synthesized by homogeneous precipitation method.
Özer, IO, Suvacı, Ender
core   +1 more source

Unsupervised Detection of Surface Defects in Varistors with Reconstructed Normal Distribution Under Mask Constraints

Applied Sciences
Surface defect detection serves as one of the crucial auxiliary components in the quality control of varistors, and it faces real challenges such as the scarcity of defect samples, high labelling cost, and insufficient a priori knowledge, which makes ...
Shancheng Tang, Xinrui Xu, Heng Li, Tong Zhou   +3 more
doaj   +1 more source

Current limiting and negative differential resistance in indium oxide based ceramics

, 2009
Indium oxide based ceramics with bismuth oxide addition were sintered in air in the temperature range 800-1300 ºC. Current-voltage characteristics of In2O3-Bi2O3 ceramics sintered at different temperatures are weakly nonlinear.
Bondarchuk, AN, Jones, Benjamin, A.B. Glot, A.N. Bondarchuk, Jones, BJ, Bondarchuk, A N, Glot, AB, R. Bulpett, Verma, N, Bulpett, R, Mazurik, SV, Mazurik, S V, B.J. Jones, Jones, B J, N. Verma, Mazurik, S.V., S.V. Mazurik, Glot, A B, Glot, A.B., Bondarchuk, A.N.   +19 more
core   +1 more source

Accurate Fault Current Phasor Estimation in Series‐Compensated Transmission Lines Using Improved Particle Swarm Optimisation

IET Generation, Transmission &Distribution, Volume 20, Issue 1, January/December 2026.
A new evolutionary search algorithm based on improved Particle Swarm Optimisation (PSO) is introduced in this study to estimate the phasor. The performance has been evaluated through extensive simulations considering transient components, harmonics, and frequency changes in noiseless and noisy conditions.
Seyedeh Mina Abed Shiadeh, Ali Akbar Abdoos, Ali Ebadi   +2 more
wiley   +1 more source

Determining the effect of bismuth oxide on the microstructure and electrical response of cold‐sintered ZnO varistors

Journal of the American Ceramic Society, Volume 109, Issue 1, January 2026.
Abstract Microstructure homogeneity and grain size reduction are needed to ensure the current uniformity and reliability required in metal oxide varistors for DC circuit breakers. Cold sintering (CS)–a low‐temperature digestive liquid and high‐pressure densification process–has previously shown reduced grain growth, but it is not clear how the lower ...
Kayla Y. Chuong, Yang Liu, Thomas Forbes, Marshall B. Frye, Lukas Graber, Lauren M. Garten   +5 more
wiley   +1 more source

Fabrication and electrical characteristics of flash-sintered SiO2-doped ZnO-Bi2O3-MnO2 varistors

Journal of Advanced Ceramics, 2020
The dense ZnO-Bi2O3-MnO2-xSiO2 (ZBMS) varistors for x = 0, 1, 2, 3 wt% were fabricated by flash sintering method under the low temperature of 850 °C within 2 min. The sample temperature was estimated by a black body radiation model in the flash sintering
Pai Peng, Yujun Deng, Jingpeng Niu, Liyi Shi, Yunzhu Mei, Sanming Du, Juan Liu, Dong Xu   +7 more
doaj   +1 more source

Three‐Level NF‐TDN Controller for AGC in Thermal‐Hydro‐Gas Power Systems Integrated With TCPS Under Nonlinear Conditions

International Journal of Energy Research, Volume 2026, Issue 1, 2026.
Automatic generation control (AGC) is vital for preserving frequency and power balance in modern interconnected power systems (IPSs), which are increasingly challenged by nonlinear dynamics, parameter uncertainties, and unpredictable load variations.
Getaneh Mesfin Meseret, Mohammad Ghiasi
wiley   +1 more source

Concept Proof of Voltage Suppression across IGBT Application for Fuse‐Current‐Limiting Hybrid DCCBs

IEEJ Transactions on Electrical and Electronic Engineering, Volume 20, Issue 12, Page 1973-1981, December 2025.
Abstract DC power systems require reliable and cost‐effective DC circuit breakers (DCCBs). In a previous study, we introduced a hybrid DCCB featuring a current‐limiting fuse, insulated gate bipolar transistor (IGBT), and a varistor connected in parallel.
Yuki Okegawa, Hu Long, Yubin He, Shungo Zen, Nozomi Takeuchi, Wataru Ohnishi, Yusuke Nakano, Naoto Kodama, Yuki Inada   +8 more
wiley   +1 more source