Results 51 to 60 of about 432 (184)

Simulation‐Based Material Design for HVDC Cable Accessories

High Voltage, Volume 11, Issue 1, Page 25-36, February 2026.
ABSTRACT The worldwide increasing demand for electricity, coupled with the need for more reliable infrastructures and more interconnected networks, has put forward high voltage direct current (HVDC) technologies for energy transmissions. Questions still arise as regards synthetic insulation for cable systems and accessories, as it remains one of the ...
Thi Thu Nga Vu, Gilbert Teyssèdre, Séverine Le Roy   +2 more
wiley   +1 more source

Technical Progress, Challenges and Prospects of HVDC Cable Accessories: A Review With Chinese Practice Insights

High Voltage, Volume 11, Issue 1, Page 1-24, February 2026.
ABSTRACT With the development of deep‐sea wind power and large‐scale onshore clean energy, the global demand for higher voltage level DC cable power transmission technology has become increasingly urgent. This paper systematically reviews the technical advancements in high voltage direct current (HVDC) cable accessories, addressing design challenges of
Zongxi Liu, Benhong Ouyang, Kaiwen Huang, Yuli Wang, Jiankang Zhao, Peng Zhao   +5 more
wiley   +1 more source

Abnormal Expansion Along the Synthesis of Zinc Stannate: A Way for Porous Ceramics Without Addition of Pore Generators

Journal of the American Ceramic Society, Volume 109, Issue 2, February 2026.
The abnormal expansion associated with the simultaneous synthesis and sintering of Zn2SnO4 from ZnO and SnO2 is due to the reaction mechanism and correlated with the conversion. This phenomenon opens the way to manufacture porous ceramics without the addition of pore generators, simplifying the process, and especially the thermal treatment.
María José Orts, Eugeni Cañas, Valentín Pérez‐Herranz, Sergio Mestre   +3 more
wiley   +1 more source

The Influence of Ni2O3 Doping Concentration on the Alternating Current Aging Characteristics of ZnO Varistor

International Journal of Ceramic Engineering &Science, Volume 8, Issue 1, January 2026.
ABSTRACT When the surge arrester is subjected to the working voltage for an extended period, it undergoes alternating current (AC) aging, which degrades the arrester's parameters and affects the safety of the power grid. Ni2O3 is an important additive in the ZnO varistor formulation, and its doping ratio significantly influences the performance of the ...
Lei Wang, Jian Zhang, Wenbo Yu, Lu Li, Xin Cheng   +4 more
wiley   +1 more source

Accurate Fault Current Phasor Estimation in Series‐Compensated Transmission Lines Using Improved Particle Swarm Optimisation

IET Generation, Transmission &Distribution, Volume 20, Issue 1, January/December 2026.
A new evolutionary search algorithm based on improved Particle Swarm Optimisation (PSO) is introduced in this study to estimate the phasor. The performance has been evaluated through extensive simulations considering transient components, harmonics, and frequency changes in noiseless and noisy conditions.
Seyedeh Mina Abed Shiadeh, Ali Akbar Abdoos, Ali Ebadi   +2 more
wiley   +1 more source

Determining the effect of bismuth oxide on the microstructure and electrical response of cold‐sintered ZnO varistors

Journal of the American Ceramic Society, Volume 109, Issue 1, January 2026.
Abstract Microstructure homogeneity and grain size reduction are needed to ensure the current uniformity and reliability required in metal oxide varistors for DC circuit breakers. Cold sintering (CS)–a low‐temperature digestive liquid and high‐pressure densification process–has previously shown reduced grain growth, but it is not clear how the lower ...
Kayla Y. Chuong, Yang Liu, Thomas Forbes, Marshall B. Frye, Lukas Graber, Lauren M. Garten   +5 more
wiley   +1 more source

Three‐Level NF‐TDN Controller for AGC in Thermal‐Hydro‐Gas Power Systems Integrated With TCPS Under Nonlinear Conditions

International Journal of Energy Research, Volume 2026, Issue 1, 2026.
Automatic generation control (AGC) is vital for preserving frequency and power balance in modern interconnected power systems (IPSs), which are increasingly challenged by nonlinear dynamics, parameter uncertainties, and unpredictable load variations.
Getaneh Mesfin Meseret, Mohammad Ghiasi
wiley   +1 more source

Concept Proof of Voltage Suppression across IGBT Application for Fuse‐Current‐Limiting Hybrid DCCBs

IEEJ Transactions on Electrical and Electronic Engineering, Volume 20, Issue 12, Page 1973-1981, December 2025.
Abstract DC power systems require reliable and cost‐effective DC circuit breakers (DCCBs). In a previous study, we introduced a hybrid DCCB featuring a current‐limiting fuse, insulated gate bipolar transistor (IGBT), and a varistor connected in parallel.
Yuki Okegawa, Hu Long, Yubin He, Shungo Zen, Nozomi Takeuchi, Wataru Ohnishi, Yusuke Nakano, Naoto Kodama, Yuki Inada   +8 more
wiley   +1 more source

Control strategy of novel hybrid commutated converter based on reverse blocking integrated gate commutated thyristor for commutation failure mitigation

High Voltage, Volume 10, Issue 3, Page 546-554, June 2025.
Abstract Commutation failure (CF) is an inherent problem faced by line commutated converter high voltage direct current (LCC‐HVDC) technology. To completely solve the problem of CF, we have proposed a novel hybrid commutated converter (HCC) technology based on reverse blocking integrated gate commutated thyristor, which can utilise two methods for ...
Zongze Wang, Zhanqing Yu, Lu Qu, Zhichang Yuan, Kangsheng Cui, Jian Shi, Biao Zhao, Rong Zeng   +7 more
wiley   +1 more source

Influence Mechanism of Micro Grain-boundary Parameters to the Electrical Properties of ZnO Varistor

工程科学与技术
ZnO varistors exhibit excellent nonlinear voltage–current characteristics and substantial energy capacity, enabling them to absorb impulse energy during power system overvoltages and thus protect the electrical equipment.
Pengfei MENG, Jingke GUO, Xiao LEI, Lei WANG, Bingbing ZHANG, Kui MIAO, Jun HU   +6 more
doaj