Results 111 to 120 of about 2,336,068 (304)
Reliability of a face scanner in measuring the vertical dimension of occlusion. [PDF]
OBJECTIVE This study evaluated the reliability of a face scanner in measuring the vertical dimension of occlusion (VDO). METHODS Fully dentate volunteers (n=20; mean-age=30.0±10.7 years) were recruited. Clinical facial measurements were obtained
Berisha, Florentin +7 more
core +2 more sources
Schematic representation of modes of microcrack nucleation, growth and temporary arrestment at different boundaries, with the criteria for crack propagation in three scenarios: (1) large notch, (2) defect/small sharp notch, and (3) long crack. This work revisits and integrates results on the fatigue behavior of advanced bainitic steels (in particular ...
Lucia Morales‐Rivas
wiley +1 more source
In spatial compatibility and Simon tasks, the response is faster when stimulus and response locations are on the same side than when they are on opposite sides.
Lameira, A.P. +11 more
core +1 more source
Postbuild annealing systematically modifies the phase fractions and morphology of EB‐PBF processed Mo–9Si–8B. Quantitative microstructure–property correlations reveal how controlled phase evolution enhances high‐temperature compressive strength and creep resistance.
Christopher Schmidt +5 more
wiley +1 more source
Cephalometric Indicators of the Vertical Dimension of Occlusion
The aim of this investigation was to establish precise indicators of the vertical dimension of occlusion (VDO) which could be used as objective parameters in prosthodontic treatment providing exact control of the reconstructed vertical dimension of occlusion, early detection of errors and correction of the vertical dimension of occlusion during ...
Strajnić, Ljijana +3 more
openaire +4 more sources
This article investigates the dependence of the properties on the manufacturing orientation in the form of the inclination angle to the build plate of LPBF‐fabricated NiTi rods with a diameter of 150–220 µm. Metallographic, chemical, thermal, and mechanical characterization show behavior under identical manufacturing conditions that ranges from ...
Sandra Herzig +2 more
wiley +1 more source
Objective: To assess the correlation of anthropometric measurement of length of index finger with occlusal vertical dimension in dentate subjects. Study Design: Analytical cross-sectional study.
Huda Khalid +5 more
doaj +1 more source
Packing dimension of vertical projections in the Heisenberg group [PDF]
It is shown that if $A$ is a Borel subset of the first Heisenberg group contained in some vertical subgroup, then vertical projections almost surely do not decrease the Hausdorff dimension of $A$.Comment: 13 ...
Harris, Terence L. J.
core
Entropy‐Driven Design of Low‐Melting‐Point Alloys via Compositionally Complex Strategy
Conventional low‐melting‐point alloys (LMPAs) are limited by a narrow compositional space and inherent property trade‐offs. This review presents an entropy‐driven design strategy that overcomes these limitations, ushering in a new class of low‐melting‐point compositionally complex alloys (LMCCAs).
Yinghui Shang +6 more
wiley +1 more source
A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation
A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler +4 more
wiley +1 more source

