Results 51 to 60 of about 553,470 (307)
Advanced Engineering Materials, EarlyView.A hierarchical porous copper current collector is fabricated via three‐dimensional printing combined with pressureless sintering to stabilize lithium metal anodes. The interconnected architecture lowers local current density, guides uniform Li deposition within pores, and suppresses dendrite growth.
Alok Kumar Mishra, Mukul Shukla
wiley +1 more source
Acceleration feedback control of human-induced floor vibrations [PDF]
Active vibration control (AVC) via a proof-mass actuator is considered to be a suitable technique for the mitigation of vibrations caused by human motions in floor structures.
Bachman +15 more
core +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Advances in Civil Engineering, 2019 The interface between anchor plate and anchorage nut can be considered as a coupling spring whose stiffness is essentially the contact stiffness related to normal force at the contact surface, thus removing the usual assumption of fixed connection.
Xingu Zhong +5 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Motion control and vibration suppression of flexible lumped systems via sensorless LQR control [PDF]
This work attempts to achieve motion control along with vibration suppression of flexible systems by developing a sensorless closed loop LQR controller. Vibration suppression is used as a performance index that has to be minimized so that motion control ...
Celebi, Besir +7 more
core
Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics
Advanced Engineering Materials, EarlyView.Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
A modern control approach to the design of the SPS control system [PDF]
The structural dynamics of the solar power satellite were considered. The requirements on the vibration of the microwave antenna and the possibility of thermal induced vibration and severe structural-thermal interactions were considered.
Gran, R.
core
Evaluating Energy Absorption Performance of Filled Lattice Structures
Advanced Engineering Materials, EarlyView.Maximum stress must be considered to robustly evaluate energy absorber designs. This approach was applied to compare all types of absorbers in a single Ashby diagram and determine the utility of filling lattice voids with a second material. High‐performance fillers can improve the performance of lattices that are limited by buckling or catastrophic ...
Christian Bonney +2 more
wiley +1 more source