Results 11 to 20 of about 458,005 (241)
Nihon Kikai Gakkai ronbunshu, 2019 Vibration suppressors are used to change the natural frequency of an elevator rope and prevent resonance. The displacement of the parts of the elevator rope at both the ends is small compared to that of the center part of the rope; therefore, it is not ...
Hiroyuki KIMURA, Masafumi KAMIYA
doaj +3 more sources
Free vibration analysis of string with vibration suppressors located in center part of string
Mechanical Engineering Journal, 2016 Vibration suppressors are used to change the natural frequency of an elevator rope and prevent resonance. The displacement of the parts of the elevator rope at both the ends is small compared to that of the center part of the rope; therefore, it is not ...
Hiroyuki KIMURA, Takahiro FUJITANI
doaj +3 more sources
Nihon Kikai Gakkai ronbunshu, 2017 Vibration suppressors are used to change the natural frequency of an elevator rope and prevent resonance. The displacement of the parts of the elevator rope at both the ends is small compared to that of the center part of the rope; therefore, it is not ...
Hiroyuki KIMURA, Takahiro FUJITANI
doaj +4 more sources
Effect of automobile operating condition on the subjective equivalence of steering wheel vibration and sound [PDF]
, 2006 The research described here was performed to define curves of subjective equivalence between steering wheel rotational vibration and sound using stimuli from different automobile operating conditions.
Giacomin, J, Ajovalasit, M
core +8 more sources
Vibration suppression of wind turbine nacelle with active electromagnetic mass damper systems using adaptive backstepping control [PDF]
, 2021 Many structural systems, such as wind turbines, are exposed to high levels of stress during operation. This is mainly because of the flow-induced vibrations caused by the wind load encountered in every tall structure.
Başaran, Sinan +2 more
core +1 more source
Study on Stability of Gas Pressure Regulator with a Built-In Silencer
Energies, 2022 Gas pressure regulators are widely used in gas transportation and distribution systems. They are designed for deep pressure reduction and maintainance with high accuracy over a wide flow range.
Dmitry Stadnik +5 more
doaj +1 more source
New Damped-Jerk trajectory for vibration reduction [PDF]
, 2014 This paper derives a jerk-shaped profile to address the vibration reduction of underdamped flexible dynamics of motion system. The jerk-limited profile is a widespread smooth command pattern used by modern motion systems.
BEAREE, Richard
core +1 more source
Human emotional response to steering wheel vibration in automobiles [PDF]
, 2013 This is the post-print (final draft post-refereeing) version of the final published paper that is available from the link below. Copyright @ 2013 Inderscience Enterprises Ltd.This study investigates what form of correlation may exist between measures of ...
Shabani, A +7 more
core +1 more source
Nihon Kikai Gakkai ronbunshu, 2016 A vibration suppressor is used to change the natural frequency of an elevator rope, and to prevent resonance. The elevator rope is modeled using a string. Linear string vibration is well known.
Hiroyuki KIMURA
doaj +1 more source
Transient vibration analysis of a completely free plate using modes obtained by Gorman's superposition method [PDF]
, 2010 This paper shows that the transient response of a plate undergoing flexural vibration can be calculated accurately and efficiently using the natural frequencies and modes obtained from the superposition method.
Ilanko, Sinniah, Yusuke, Mochida
core +1 more source