Results 11 to 20 of about 1,509 (163)
Upgrading the Seismic Capacity of Pile-Supported Wharfs Using Semi-Active Liquid Column Gas Damper [PDF]
Journal of Applied and Computational Mechanics, 2020 One of the most important structures in the ports is the wharf. The most common one is the pile-supported wharf. This type of wharf is consisted of a number of piles and one deck which placed on the piles.
Reza Dezvareh
doaj +1 more source
Energies, 2022 The work deals with a newly developed prototype of an electrical control unit (ECU) for a magnetorheological (MR) damper powered by energy harvested from vibrations.
Arkadiusz Kozieł +2 more
doaj +1 more source
The Journal of Engineering, 2015 Conventional band-pass filter (BPF)-based damper is commonly employed to damp the vibrations in the drive train caused by turbulent winds. However, for the case of grid disturbances or faults resultant torsional vibrations, the performance of the BPF ...
Libo Liu, Da Xie
doaj +1 more source
Characteristics of the asymmetric Stockbridge damper [PDF]
MATEC Web of Conferences, 2021 The Stockbridge damper (tuned mass absorber) is used on overhead transmission power lines to suppress wind-induced vibrations. These power lines get exposed to various types of wind motions that cause them to vibrate and this causes fatigue failure at ...
Zondi Zakhele +2 more
doaj +1 more source
Supression of mechanical oscillations in a nonlinear systems with restriction
Lietuvos Matematikos Rinkinys, 2023 The application of the dynamical dampers in the mechanical systems, when the sources of stimulation are impossible to abolish, is one of the ways to fight against the harmful vibrations.
Genovaitė Zaksienė
doaj +3 more sources
Study on the Development of Passive MR Damper with Displacement-Dependent Damping Characteristics
Journal of Fluid Science and Technology, 2010 In this paper, we propose a new concept of a magneto-rheological (MR) fluid damper, which is a passive MR fluid damper. The passive MR damper has no electrical devices, such as a sensor, power supply and controller, and hence, it has an advantage in ...
Takahiro MURAKAMI +2 more
doaj +1 more source
Improvement of the Dynamic Quality of Cantilever Boring Bars for Fine Boring
Machines, 2022 The paper presents ways to reduce the vibrations of special cantilever boring bars mounted on spindle heads of finishing and boring machines. Special cantilever boring bars are designed for machining holes in non-standard conditions, for example, when ...
Gennadii Oborskyi +5 more
doaj +1 more source
Inertial mass damper for vibration control of cable with sag
Journal of Low Frequency Noise, Vibration and Active Control, 2020 It has been theoretically predicted that superior supplemental damping can be generated for a taut cable with an inertial mass damper. This paper extends previous studies to investigate the effect of the cable sag on the efficiency of an inertial mass ...
Zhi-Hao Wang +3 more
doaj +1 more source
Dilatant-Fluid Torsional Vibration Damper for a Four-Stroke Diesel Engine Crankshaft
Polish Maritime Research, 2023 This paper presents a study of a viscous torsional vibration damper for a crankshaft of a four-stroke diesel engine. The reliable operation of a widely used silicone-type viscous damper depends on the ability of the silicone oil to absorb the energy of ...
Kozytskyi Sergiy, Kiriian Sergii
doaj +1 more source
Blast Response of Elevated Water Tank Staging with Metallic Damper [PDF]
E3S Web of Conferences, 2021 In the present paper work an attempt has been made to study the dynamic behaviour of the elevated water tank staging by using x-plate metallic damper subjected to blast induced ground vibrations.
Balaraju Boda, Manchalwar Atulkumar
doaj +1 more source