Results 101 to 110 of about 1,545 (212)
It has been established that the complex Thevenin’s circuit equivalent does not adequately reproduce such energy char-acteristics of the AC primary circuit as active power and power factor.
М.Ю. Артеменко +5 more
doaj +1 more source
This paper presents the results of analyzing the change in the nonlinear impedance of plasma in a dielectric barrier discharge. The volt-ampere characteristics of the plasma were obtained experimentally. The dependencies of their changes on the amplitude
A. N. Osipov, Т. Ma, V. A. Rokach
doaj +1 more source
It is well-known that in silicon microwave diodes with diffusion p-n transition the process of preparation of the p-n junction in the area of transition and in the diffusion p"+ layer is accompanied, as a result of changes of the lattice parameters,
Statov, V. +2 more
core
Properties moulded thin-film nanostructure
Are considered: technology of reception of thin-film frame metal-dielectric-metal; the properties got by frame as a result of electrical moulding in strong electric field in vacuo: volt-ampere characteristic, issue of electrons in vacuum.
Pavel E Troyan, Vladimir I Zelenskiy
core +1 more source
Asymmetrical Four-Phase 8/6 Switched Reluctance Motor for a Wide Constant Power Region
In this paper, the methodology for designing an asymmetrical four-phase 8/6 switched reluctance motor (SRM) that achieves approximately constant output power over a wide speed range is described.
Dragan S. Mihić +2 more
doaj +1 more source
Technology of automatic submerged-arc welding and cladding by low-density current
Изложены результаты применения источников питания с комбинированной внешней вольт-амперной характеристикой для сварки полотен в щелевой зазор и для восстановления наплавкой гребней колес грузовых вагонов.The paper describes the results of application of ...
Ярос, Ю.А. +2 more
core +2 more sources
Enhancing Current Sharing in Metal Oxide Varistors Using Dynamic U-I Characteristic Analysis [PDF]
Metal oxide varistors (MOVs) are widely used as protective elements in power electronics (PEs) to clamp overvoltage and dissipate energy. However, the conflict between the increasing power capacity of PEs and the limited energy-handling capacity of ...
Wu, Yifei +3 more
core +1 more source
Cs3(HSO4)2(H2PO4) and Cs4(HSO4)3(H2PO4) crystals are being studied in connection with the prospects of their use as materials for electrochemical devices, including fuel cells, providing direct conversion of chemical energy into electrical energy in the ...
A. L. Tolstikhina +2 more
doaj +1 more source
Wing-slope techniques for the analysis of Langmuir probe characteristics
Wing-slope positive ion temperature measurement technique for Langmuir probe volt-ampere characteristic ...
Bettinger, R. T.
core
THE PHYSICAL ESSENCE OF THE VOLT-AMPERE CHARACTERISTICS OF SOLAR CELLS
To determine the photovoltaic efficiency of solar cells, it is necessary to obtain a volt-ampere characteristic. This work discusses the mechanism of converting light energy into electrical energy in a solar cell, as well as the methods for obtaining and describing the volt-ampere characteristic.
openaire +1 more source

